475282
111
Zoom out
Zoom in
Previous page
1/128
Next page
Appendices 111
Remove the Shield
1. Using a Phillips screwdriver, remove the screws that
secure the top plate and lift off the plate. Keep the
plate and screws for reuse. See figure 1.
Figure 1. Remove the
screws securing the
top plate and lift off
the plate.
Top Plate
2. Note the location of the six clips that hold the
Diamond Shield in place. Slide the card along the
channel until it meets each clip. See figures 2 and 3.
See figure 3 detail
Figure 2. Six clips hold the Diamond Shield on the TV.
Diamond Shield
Slide card in channel
to locate clips. The
clips are visible at the
edge of the Diamond
Shield.
Figure 3. Locating the clips
The Diamond Shield ™ is an optional protective cover for the front of the TV screen. Models WD-62927 and WD-73927
come from the factory with the Diamond Shield installed. For Models WD-62827 and 73827, the Diamond Shield may
be purchased separately.
These instructions explain removal and installation of the Diamond Shield™ and the decorative trim that covers gaps
around the TV screen when the shield not installed.
You need the following for this procedure:
Trim kit (included with the TV)
Phillips screwdriver
Small plastic card or plastic putty knife. An expired credit card or similar expendable card works well.
Soft cotton gloves
Note: Use care to avoid scratching the TV screen or Diamond Shield.
This procedure is best performed by two people.
Appendix H: Diamond Shield Removal and Installation
111


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Mitsubishi WD-73827 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Mitsubishi WD-73827 in the language / languages: English as an attachment in your email.

The manual is 7,8 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info