475282
70
Zoom out
Zoom in
Previous page
1/128
Next page
70 Chapter 5. TV Menu Operations
Record
Figure 14
The Record menu allows you to set up recordings, view
the record list, and set defaults for your recording devices.
Figure 14. Record Menu
Recording Setup
Figure 15
Figure 15. Recording Setup screen
In the recording Setup screen you tell the TV what, where,
and when to record. There are two ways to open the
Recording Setup screen:
• selectRecordfromtheRecordmenu.
• pressREC on the remote control when viewing a
recordable source.
Your TV can stop recordings automatically and it can
send the signals from one external playback device to a
different external recording device.
You can schedule the recording to take place at a later
time and program the recording duration for a minimum
of 30 minutes and a maximum of six hours in 30-minute
increments. The default is one hour.
The default recording device is the TV Disc, which can
record both digital and analog programs. When a digital
recording is being made, the TV can direct the same
source signals to an external recording device using the
IEEE 1394 cable.
Record Menu
Recording Now
Can be used when viewing Antenna 1 or 2, an IEEE 1394
device, or a non-recording traditional device.
To initiate recording now:
1. Press REC (record) on the TV remote or press
ENTER if the Record menu is displayed.
2. Review the Record To (destination) device (TV Disc)
and duration. Change if necessary.
3. Press REC a second time to initiate recording.
Time-Delayed Recording
To initiate a time-delayed recording:
1. Set the TV to the source you want to record.
2. Press REC (record) on the TV remote or press
ENTER if the Record menu is displayed.
3. Press ADJUST or to select the channel, device
to record to, duration time, start time (press ENTER
after selecting hour and minutes to set the time) and
day.
4. Select Add and press ENTER to add the recording
to the record list. If your selection is successful, a
confirmation message will be displayed. If you pick
overlapping times, day(s), or destination devices, you
will see a message stating there is a conflict.
5. To exit, press HOME on the TV remote after all
recordings have been added.
If you have a digital source and make an analog recording
to a VCR, the TV converts the digital signals to analog
format and sends the analog output to the VCR through
the RECORD OUTPUT jacks.
The TV can convert analog programs to digital format.
This allows you to record analog programs to a digital
recording device (TV Disc, A/V Disc, DVCR).
During recording, you can:
• viewadifferentdevice
• viewadifferentchannel(inmostcases)
• powerofftheTV.
When recording to a VCR or A/V disc, press PAUSE to
temporarily stop recording and press PAUSE again to
resume recording. Use the PAUSE key in this manner to
selectively record only the program segments you want.
IMPORTANT
Recordings scheduled on this screen are
independent of recordings scheduled through
TV Guide On Screen®. Recordings scheduled
with TV Guide On Screen have priority if
there is a conflict between the two recording
schedules.
IMPORTANT
See Appendix I for a list of recording and
viewing combinations available for this TV.
70


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Mitsubishi WD-73827 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Mitsubishi WD-73827 in the language / languages: English as an attachment in your email.

The manual is 7,8 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info