475314
12
Zoom out
Zoom in
Previous page
1/71
Next page
12
Part II : Installation
Front Control Panel
Many remote control buttons are duplicated on the front control panel. These buttons are shaded in figure 1.
Please see Remote Control Functions, pages 48 - 55, for an explanation of their usage.
Figure 1. Front Control Panel Figure 2. Located under Control Panel Overhang
1
Status indicator
This indicator informs of the status of the projection TV. See below.
2
Power indicator
This indicator informs of the power condition of the projection TV. See below.
3
A/V Reset
Press this button to reset the A/V memory on all inputs to the factory default settings. Please
see
A/V Memory Reset
, page 41, for instructions.
4
PC-2
This input can be used for the convenient connection of a compatible computer. Please see
Appendix B
, page 59, for signal compatibility.
5
Input 5 (S-VIDEO / VIDEO)
This input can be used for convenient connection of a camcorder or other video device. Please
note that if you connect to the S-VIDEO terminal, the VIDEO terminal is deactivated.
6
L - AUDIO - R
Audio input to the AUDIO IN terminal on the front panel is possible for a component connected
to either PC-2 or Input 5.
Front control Panel Functions
STATUS POWER
POWER
VOLUME
ADJUST
CHANNEL ENTER
ENTER
ADJUST
MENU
MENU
A/V RESET
CANCEL
INPUT
1 2
3
S-VIDEO VIDEO
PC-2
INPUT - 5
L–AUDIO–R
4 5
6
Steady
green
STATUS POWER
CONDITION NOTES
Under normal operation
Abnormal operation notice
The POWER is ON
Lamp start-up (for 30 seconds)
Off
OffOff
Steady
yellow
Steady
yellow
Off
Off
Initialization when first plugging inyour TV, or lamp cooling
(10 - 45 seconds)
Stand-by (When the TV is set to turn on at a specific time.)
TV will turn on in 10 - 30seconds.
• Close the cover correctly.
Off
Off
Off
Off
Off
Blinking
green
Any state
Blinking
yellow/red
STATUS POWER
CONDITION POSSIBLE SOLUTIONS
Lamp usage warning. (Usage total about 4, 000 hours.)
Lamp failure
Lamp cover or filter cover is open.
Service required. • Contact your dealer.
Unusual temperature
The air-filter is dirty.
The room temperature is too high.
Clean the filter. (See page 64).
Relocate the projector to a cooler place.
• Replace the lamp. (See page 61.)
Wait 1 minute, then press the POWER button.
• If the above operation is not effective, replace
the lamp.
Blinking
red
Blinking
yellow/green
Blinking
red/green
Off
Steady
red
12


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Mitsubishi WD-65000 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Mitsubishi WD-65000 in the language / languages: English as an attachment in your email.

The manual is 2,27 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info