475281
112
Zoom out
Zoom in
Previous page
1/128
Next page
112 Appendices
Appendix H: Diamond Shield Removal and Installation, continued
3. Release the six clips that hold the Diamond Shield in
place. Work on one side at a time, starting with the
top clip. Follow these steps:
(1) Refer to figure 4. Hold the plastic card vertically,
angled slightly toward the middle of the screen.
(2) Insert the card into the channel, alongside the
clip.
(3) Refer to figure 5. While keeping the card pressed
in on the clip, angle the card outward, away from
the middle of the screen, and pry out the clip.
WARNING
Sharp edges! Always wear gloves to handle, lift,
install, and remove the Diamond shield.
4. When all clips are released, lift the shield up out of
the lower channel and away from the TV.
5. Store the Diamond Shield protected from scratches
in a clean, dust-free area.
Notched edge
down
Figure 6. Center the trim piece, notched side down, and
set it in the channel below the screen.
TV Screen
Raised Lip
Trim Piece
Channel
Figure 7. The lower trim piece fits snugly into the channel
and over the raised lip that runs along the bottom of the
TV screen.
Diamond Shield
Angle card
toward shield
before inserting
Top View
Note
Angle
of Card
Figure 4. To release
the clip, insert the card
alongside the clip at the
angle shown.
Figure 5. Pry the clip out
of the channel.
Clip
Top View
Install Trim
Note: Install the trim pieces in the order described here.
6. Install the lower trim piece as follows:
(1) Center the trim piece in front of the TV, notched
edge down, and set it in the channel below the
screen. See figure 6.
(2) Refer to figure 7. With the trim piece resting in the
channel, hook the trim piece onto the raised lip at
the bottom edge of the TV screen.
To do this,
a. Gently press the trim piece against the TV
frame.
b. Push the trim up slightly to clear the raised
lip.
c. Press down firmly on the top edge of the
trim piece to push it snugly into place over
the raised lip and into the channel. Be sure
to press along the entire length of the trim to
fully seat it.
112


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Mitsubishi WD-62927 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Mitsubishi WD-62927 in the language / languages: English as an attachment in your email.

The manual is 7,8 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info