475287
11
Zoom out
Zoom in
Previous page
1/108
Next page
10
11
Front Control Panel
The buttons on the Front Control Panel highlighted in gray are duplicated on the remote control. The top row of
labels show the control functions when there are no TV menus displayed on the screen. The bottom row of labels
show the control functions when the TV menus are displayed on the screen or when a special function has been
activated. See Remote Control Overview, for further details on the functions of these buttons.
System Reset
If the TV will not respond to either the remote control or the front panel controls and/or will not power Off, press the
SYSTEM RESET button with a pointed item like the end point of a paperclip. The TV will turn Off and the TIMER
light will flash quickly for about one minute. When the TIMER light stops flashing, you may again turn on the TV. The
changes you made the last time the TV was on before you used the SYSTEM RESET button may be lost, however,
the changes that were previously saved are not lost.
Indicators
Please refer to the table below for conditions when the indicator lights will display.
COLOR LAMP LIGHT
INDICATOR
TIMER/
POWER
COLOR STATUS LIGHT INDICATOR
None (off) Power off Power off None (off) Power off
Green
(steady light)
n/a Power on Green
(steady light)
n/a
Green
( fast blinking light)
n/a Starting
up*
Green
( fast blinking light)
n/a
Green
(blinking light)
Power just turned off,
TV cooling down (1
minute). Cannot turn
the TV back on until
blinking stops.
TV Timer
is set
Green
(blinking light)
n/a
Yellow
(steady light)
Lamp life end warning.
A new lamp should be
purchased.
See Appendix H.
n/a Yellow
(steady light)
Operating temperature is too high.
The dust filter may be dirty. See
Appendix H.
or
The room temperature too hot. Turn off
TV until the room is cooler.
Yellow
(blinking light)
Lamp cover door is
open
or no lamp installed.
See Appendix H.
n/a Yellow
(blinking light)
The filter cover is open or not secure.
See Appendix H.
Red
(steady light)
Lamp has failed,
replacement is
required.
See Appendix H.
n/a Red
(steady light)
Service required.
Turn off TV and call your dealer or a
Mitsubishi Authorized Service Center.
See www.mitsubishi.com or call 1-800-
332-2119.
Red
(blinking light)
n/a n/a Red
(blinking light)
Service required.
Turn off TV and call your dealer or a
Mitsubishi Authorized Service Center.
See www.mitsubishi.com or call 1-800-
332-2119.
*Each time the TV is plugged into a wall electrical outlet, when power is restored
after a power failure, or when using
the SYSTEM RESET button, this light will flash for about one (1) minute.
A/V Reset
There may be times when you wish to reset the A/V (Audio and Video) settings back to the factory defaults. To return
all of the settings at once, press GUIDE and FORMAT on the front panel at the same time. To reset the defaults for
individual devices, use the A/V Memory Reset selection on the AudioVideo menu.
<
DEVICEGUIDE
CANCEL
MENU
ENTER
MENUFORMAT
CH
<
>
ADJUST
VOL
<
>
>
< >
POWER
SYSTEM
RESET
LAMP STATUS TIMER
11


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Mitsubishi WD-62725 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Mitsubishi WD-62725 in the language / languages: English as an attachment in your email.

The manual is 8,3 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info