475312

Mitsubishi WD-52327 Manual

66
Zoom out
Zoom in
Previous page
1/72
Next page
66
67
Troubleshooting
Problem Possible Solution
1. The TV remote control does not work. • Check that the batteries are installed correctly.
• Check that the selected switch is set to “TV”.
• Be no further than 20 feet from the TV when using the remote control.
2. The TV takes several seconds to respond to
channel commands.
• Press ENTER after a channel number to avoid delays.
• Use the three digit number, i.e 002 for channel 2.
3. You cannot access a channel. • Use number keys instead of CHANNEL up/down.
• Be sure the channel you want to view is in memory.
• Check that the TV is turned to the correct input source for that
channel, by pressing the INPUT button.
• Make sure the V-Chip Lock is not set (pages 44-45).
4. On-screen displays appear each time you
change a function.
• This is part of normal TV operation.
5. The TV cannot be programmed to turn on
automatically.
• The TV may be locked.
• The clock may not be set.
6. There is no sound even when the volume is
turned up.
• Check to see if the MUTE button is on.
• The TV’s “Listen to:” setting may be set to SAP.
• Check that “TV Speakers” setting is On.
7. You have forgotten your lock passcode. • See Appendix A, Bypassing the V-Chip Lock (page 57).
8. Connected devices do not work correctly
when the TV is off.
• Energy mode has been set to Low. Change to Standard (page 36).
9. Lamp indicator light is a constant red. • Turn the TV off for at least 2 minutes. Turn back on. If light is still
red, the lamp has failed, replace it. See Appendix F for lamp
replacement information.
10. Lamp indicator light is a constant yellow. • Lamp’s elapsed time has exceeded 5,000 hours. Purchase a new
lamp. See Appendix F for lamp replacement information.
11. Lamp indicator light is a flashing yellow. • Lamp cover door is open or lamp cartridge is not secure. See
Appendix F for lamp replacement information.
12. Status indicator light is a constant yellow. • Operating temperature or room temperature has exceeded proper
levels. Clean the TV’s dust filter or cool the room. See AppendixE
for filter cleaning information.
13. Status indicator light is a constant/flashing
red.
• Service is required. Contact your dealer or a Mitsubishi Authorized
Service Center to arrange for a service evaluation listings of
Mitsubishi Authorized Service locations can be obtained from our
web site, www.mitsubishi-tv.com or by calling 1-800-332-2119.
14. PIP does not display a picture. • Make sure the V-Chip Lock is not set (page 44-45).
• Not all inputs can be displayed as a PIP (page 20).
15. The sound does not match the screen
picture.
• The TV’s “Listen to:” setting may be set to SAP.
• If using stereo or A/V receiver speakers, check input selection on the
stereo or A/V receiver.
• If using stereo or A/V receiver, check that AUDIO is from MONITOR
OUT on TV’s back panel.
16. There is a large black or gray rectangle on
the screen.
• TV closed captioning has been set to “text” mode, but no text
information is being broadcast. Turn Off in the CAPTIONS menu
(page 38).
17. Picture is out of focus. • Check the Sharpness settings (page 52).
18. You cannot see a picture when you play a
VCR tape.
• If you connected your VCR with A/V cables, use the INPUT button to
select the Input source (INPUT-1, INPUT-2, or INPUT-3) that the VCR
is connected to.
• Check your VCRs owner’s guide for further troubleshooting.
… 66 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Mitsubishi WD-52327 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Mitsubishi WD-52327 in the language / languages: English as an attachment in your email.

The manual is 3,84 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info