604715
27
Zoom out
Zoom in
Previous page
1/32
Next page
– 26 –
Notice
Air ow
Noise
Others
Air ow is not blown out when starting the HEATING
operation.
RUN light blinks slowly
(1.5 sec ON, 0.5 sec OFF)
Air ow has stopped to prevent blowing out of cold air until the
indoor heat exchanger has warmed up. (2 to 5 min.) (HOT
KEEP program)
Air ow is not blown out for 5 to 15 min. or blown out not
warm wind for a moment at HEATING operation.
RUN light blinks slowly
(1.5 sec ON, 0.5 sec OFF)
When outdoor temperature is low and humidity is high, the
unit sometimes performs defrosting automatically. Please
wait. During defrosting, water or steam may escape from the
outdoor unit.
Air ow is not blown out when starting the DRY operation.
(RUN light is on)
The indoor fan may stop to prevent re-evaporation of
dehumi ed moisture and to save energy.
You hear a slight gurgling sound. This is caused by refrigerating liquid moving within the unit.
You hear a slight cracking sound. This is caused by heat expansion or contraction.
You hear a hissing or clicking sound. This is caused by the operation of the refrigerant control
valves or electric components.
Whistling noise is heard from the outdoor unit. The noise means that the revolution speed of the compressor
is increasing or decreasing.
Sometimes a “Shooooo” sound might come for a short
time from the unit that is turned off.
This is the sound when operation of another indoor unit is
stopped.
The unit does not restart immediately after you have
stopped it.
(RUN light is on)
Not
operating?
Restart is blocked for 3 minutes after you have stopped the
operation to protect the unit.
Please wait for
three minutes.
The three-minute protection timer in the microcomputer
automatically starts it up again.
Some steam escapes during COOL operation. This may occur if the room’s temperature and humidity are
very high. It disappears as soon as the temperature and
humidity decrease.
There is a slight smell. Air blown out during operation may smell. This is caused by
tobacco or cosmetics adhering to the unit.
After a power cut, the unit does not restart even if power
has been restored.
If the auto restart function is not set, the unit will not restart
automatically. Use the remote control to start the operation
again.
Remote control signals are not received. Remote control signals may not be received if the unit display
section is exposed to direct sunlight or other bright light.
If so, cut out the sunlight or reduce the other light.
Moisture may form on the air outlet grills. If the unit is operated for a long time in high humidity, moisture
may form on the air outlet grills and start dripping.
Fan will not stop immediately after unit operation was
stopped.
Indoor fan : Fan will not stop after 2 hours if set to CLEAN
operation.
Outdoor fan : Fan will not stop about a 1 minute period in
order to protect the unit.
RUN light stays on even though operation was stopped. The RUN light illuminates during CLEAN operation.
Run light turns off when CLEAN operation ends.
27


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Mitsubishi SRR50ZM-S at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Mitsubishi SRR50ZM-S in the language / languages: English as an attachment in your email.

The manual is 4,01 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Mitsubishi SRR50ZM-S

Mitsubishi SRR50ZM-S User Manual - German - 30 pages

Mitsubishi SRR50ZM-S User Manual - Dutch - 34 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info