617119

Mitsubishi Outlander Sport - 2014 Manual

109
Zoom out
Zoom in
Previous page
1/384
Next page
Starting the engine
5-46 Features and controls
5
Do not operate the starter motor continu-
ously for longer than 15 seconds as this
could run the battery down or damage the
starter motor. If the engine does not start,
turn the ignition switch back to the “OFF”
position, wait a few seconds, and then try
again. Trying repeatedly with the engine
or starter motor still turning will damage
the starter mechanism.
If the engine will not start because the bat-
tery is weak or discharged, refer to
“Jump-starting the engine” (on page 8-2)
for instructions.
A longer warm up period will only con-
sume extra fuel. The engine is warmed up
enough for driving when the bar graph of
engine coolant temperature display starts
to move. Refer to “Interrupt display
screen (With ignition switch or operation
mode in ON)” on page 5-92.
This model is equipped with an electronically
controlled fuel injection system. This is a sys-
tem that automatically controls fuel injection.
There is usually no need to depress the accel-
erator pedal when starting the engine.
The starter should not be run for more than 15
seconds at a time.
To prevent battery drain, wait a few seconds
between attempts to restart the engine.
1. Make sure all occupants are properly
seated with seat belts fastened.
2. Insert the ignition key.
3. Make sure the parking brake is applied.
4. Press and hold the brake pedal down with
your right foot.
5. Press and hold the clutch pedal all the way
down (manual transaxle).
6. On vehicles equipped with manual trans-
axle, place the gearshift lever in the “N”
(Neutral) position.
On vehicles equipped with continuously
variable transmission (CVT), make sure
the selector lever is in the “P” (PARK)
position.
7. Turn the ignition switch to the “ON” posi-
tion and make certain that all warning
lights are functioning properly before
starting the engine.
8. Turn the ignition switch to the “START”
position without pressing the accelerator
pedal. Release the key when the engine
starts.
Tips for starting
Never run the engine in a closed or poorly
ventilated area any longer than is needed
to move your vehicle out of the area. Car-
bon monoxide gas, which is odorless and
extremely poisonous, could build up and
cause serious injury or death.
Do not push-start the vehicle.
Do not run the engine at high rpms or drive
at high speeds until the engine has had a
chance to warm up.
Release the ignition switch as soon as the
engine starts. Otherwise, the starter motor
will be damaged.
Starting the engine
On vehicles equipped with CVT, the starter
will not operate unless the selector lever is in
the “P” (PARK) or “N” (NEUTRAL) posi-
tion.
For safety reasons, start the engine in the “P”
(PARK) position so that the wheels are
locked.
Minor noises may be heard on engine start-
up. These will disappear as the engine warms
up.
BK0202700US.book 46 ページ ２０１３年３月２８日　木曜日　午前１１時５４分
… 109 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Mitsubishi Outlander Sport - 2014 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Mitsubishi Outlander Sport - 2014 in the language / languages: English as an attachment in your email.

The manual is 49,22 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info