617119

Mitsubishi Outlander Sport - 2014 Manual

84
Zoom out
Zoom in
Previous page
1/384
Next page
Free-hand Advanced Security Transmitter (F.A.S.T.-key) (if so equipped)
Features and controls 5-21
5
Wait a few seconds, and then press the
engine switch to crank the engine again
while depressing the brake pedal (CVT)
or the clutch pedal (manual transaxle), but
do not push the accelerator pedal. If the
engine fails to start, repeat these proce-
dures. If the engine still will not start, con-
tact your local Mitsubishi Motors dealer
or a repair facility of your choice for
assistance.
Startability of continuously variable trans-
mission (CVT) vehicles with an ambient
temperature of -22 °F (-30 °C) or lower
When the ambient temperature is -22 °F (-30
°C) or lower, it may not be possible to start
from a standstill even with the selector lever
in the “D” (DRIVE) position.
This phenomenon occurs because the trans-
axle has not warmed up sufficiently; it does
not indicate a problem. If this occurs, place
the selector lever in the “P” (PARK) position
and let the engine idle for at least 10 minutes.
The transaxle will warm up, and you will be
able to start normally.
Do not leave the vehicle during warm-up
operation.
N00568200014
1. Stop the vehicle.
2. Fully engage the parking brake while
depressing the brake pedal.
3. On vehicles with a manual transaxle,
press the engine switch to stop the engine,
and then move the gearshift lever to the
1st (on a uphill) or “R” (Reverse) (on a
downhill) position.
On vehicles equipped with continuously
variable transmission (CVT), move the
selector lever to the “P” (PARK) position,
and then press the engine switch to stop
the engine.
N00568300028
Insert the F.A.S.T.-key into the key slot in the
glove box. Starting the engine and changing
the operation mode should be now possible.
Remove the F.A.S.T.-key from the key slot
after starting the engine or changing the oper-
ation mode.
Stopping the engine
Do not operate the engine switch while
driving except in an emergency. If the
engine is stopped while driving, the brake
servomechanism will cease to function and
braking efficiency will deteriorate. Also,
the power steering system will not func-
tion and it will require greater manual
effort to operate the steering. This could
result in a serious accident.
If you have to bring the engine to an emer-
gency stop while driving, press and hold the
engine switch for 3 seconds or more, or press
it quickly 3 times or more. The engine will
stop and the operation mode will go to ACC.
On vehicles equipped with continuously
variable transmission (CVT), do not stop the
engine with the selector lever in any position
other than the “P” (PARK) position. If the
engine is stopped with the selector lever in
any position other than the “P” (PARK) posi-
tion, the operation mode will go to ACC
rather than OFF.
Put the operation mode in OFF after placing
the selector lever in the “P” (PARK) posi-
tion.
If the F.A.S.T.-key is not operat-
ing properly
BK0202700US.book 21 ページ ２０１３年３月２８日　木曜日　午前１１時５４分
… 84 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Mitsubishi Outlander Sport - 2014 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Mitsubishi Outlander Sport - 2014 in the language / languages: English as an attachment in your email.

The manual is 49,22 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info