617073
403
Zoom out
Zoom in
Previous page
1/446
Next page
Emission-control system maintenance
9-22 Vehicle care and maintenance
9
detergent or non-abrasive cleaner to clean the
blades and glass areas.
Replace the blades if they continue to streak
or smear.
If the blades are frozen to the windshield or
rear window, do not operate the wipers until
the ice has melted and the blades are freed,
otherwise the wiper motor may be damaged.
N00940800328
Your vehicle is equipped with an emission-
control system that meets all the requirements
of the U.S. Environmental Protection Agency
and Environment Canada. The emission-con-
trol system is made of:
a positive crankcase ventilation system
an evaporative emission-control system
an exhaust emission-control system
To be sure the emission-control system works
properly, have your vehicle inspected and
maintained by an authorized Mitsubishi
Motors dealer or a repair facility of your
choice. This should be done at the time or
mileage specified in the “WARRANTY AND
MAINTENANCE MANUAL”.
These, and all the other “general” mainte-
nance services listed in this manual, need to
be performed to keep your vehicle running
properly and reliably.
You should also have an inspection and ser-
vice any time you suspect a malfunction.
N00940900231
Spark plugs must fire properly to ensure
proper engine performance and emission-
control.
Do not reuse spark plugs by cleaning or
regapping. Spark plugs should be replaced at
the mileage specified in the “WARRANTY
AND MAINTENANCE MANUAL”.
N00941000040
Check the hose surfaces for any heat and
mechanical damage, hard and brittle rubber,
cracking, tears, cuts and abrasions. Pay spe-
cial attention to the hoses closest to high heat
sources such as the exhaust manifold. Check
all the hose connections, such as clamps and
couplings, to make sure they are secure and
that there are no leaks. If you see any wear or
damage, replace the hoses immediately.
NOTE
Do not run the wipers on dry glass for a long
time. This wears out the rubber and can
scratch the glass.
During cold weather
Emission-control system
maintenance
NOTE
To meet government regulations and pro-
mote cleaner air, your vehicle is equipped
with an onboard diagnostic system (OBD).
The engine electronic control module that
controls OBD functions stores various data
(especially about the exhaust emissions).
This data will be erased if the battery cable is
disconnected, which could make a rapid
diagnosis difficult. Do not disconnect the
battery cable when the engine malfunction
indicator (“SERVICE ENGINE SOON” or
“Check engine light”) is ON.
Spark plugs
NOTE
Use the recommended or equivalent spark
plugs listed under “Engine specifications” on
page 11-6. Use of other plugs could cause
engine damage, loss of performance or radio
noise.
Fuel hoses
BK0211800US.book 22 ページ 2014年3月12日 水曜日 午後2時42分
403


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Mitsubishi Outlander - 2015 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Mitsubishi Outlander - 2015 in the language / languages: English as an attachment in your email.

The manual is 62,42 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info