617123

Mitsubishi Lancer - 2014 Manual

126
Zoom out
Zoom in
Previous page
1/434
Next page
Starting and stopping the engine
Features and controls 5-59
5
from a standstill even with the selector lever
(CVT) or the gearshift lever (Twin Clutch
SST) in the “D” (DRIVE) position.
This phenomenon occurs because the trans-
axle has not warmed up sufficiently; it does
not indicate a problem. If it occurs, place the
selector lever (CVT) or the gearshift lever
(Twin Clutch SST) in the “P” (PARK) posi-
tion and let the engine idle for at least 10 min-
utes.
The transaxle will warm up, and you will be
able to start normally.
Do not leave the vehicle during warm-up
operation.
N00547600015
At high altitude locations, the idle speed may
be higher. This is done in order to stabilize
the idle speed when the power steering sys-
tem and other systems operate. It does not
indicate a malfunction.
N00542300088
1. Bring the vehicle to a complete stop.
2. Fully engage the parking brake while
depressing the brake pedal.
3. For vehicles with a manual transaxle, turn
the ignition switch to the “LOCK” posi-
tion to stop the engine, and then move the
gearshift lever to the 1st (on a uphill) or
“R” (Reverse) (on a downhill) position.
For vehicles with continuously variable
transmission (CVT) or Twin Clutch SST,
place the selector lever (CVT) or the gear-
shift lever (Twin Clutch SST) in the “P”
(PARK) position, and then turn the igni-
tion switch to the “LOCK” position to
stop the engine.
Idle speed in high altitude area
Stopping the engine
NOTE
For vehicles with Twin Clutch SST, the
engine will stop and the vehicle power will
turn off approximately 1 second after the
ignition switch is turned to the “LOCK”;
position.
The reason for this is that, in the time from
when the ignition switch is turned to the
“LOCK” position until the engine stops, the
gears inside the Twin Clutch SST disengage
so that the engine will start smoothly the
next time it is started.
Two clutches installed in the Twin Clutch
SST alternately engage and disengage to
achieve smooth shifting.
In addition, the gear on the side with the free
clutch is engaged, therefore, quick shifting is
performed.
If the engine was stopped with the gear
engaged like this, it would provide resistance
the next time the engine is started. Therefore,
the gear disengages in the approximately 1-
second period until the engine stops.
For vehicles with Twin Clutch SST, do not
operate the gearshift lever or the accelerator
pedal for approximately 1 second until the
engine stops.
… 126 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Mitsubishi Lancer - 2014 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Mitsubishi Lancer - 2014 in the language / languages: English as an attachment in your email.

The manual is 60,3 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info