493681
54
Zoom out
Zoom in
Previous page
1/59
Next page
EN-54
Troubleshooting
The projector does not turn on.
No picture
Blurred image
Remote control does not work
The password is incorrect
The LAN function cannot be used
Cause Remedy
There is no power from the power cable.
Plug the power cord into the AC inlet on the projector, and plug
the power cord into the power outlet. If the power outlet has a
switch, make sure that it is switched on.
Attempting to turn the projector on again during
the cooling process.
Wait until the cooling down process has completed.
Cause Remedy
The video source is not turned on or connected
correctly.
Turn the video source on and check that the signal cable is
connected correctly.
The projector is not correctly connected to the
input signal device.
Check the connection.
The input signal has not been correctly selected.
Select the correct input signal with the SOURCE key on the
projector or remote control.
The lens cover is still closed. Open the lens cover.
Cause Remedy
The projection lens is not correctly focused. Adjust the focus of the lens using the focus ring.
The projector and the screen are not aligned
properly.
Adjust the projection angle and direction as well as the height of
the unit if necessary.
The lens cover is still closed. Open the lens cover.
Cause Remedy
The battery is out of power. Replace the battery with a new one.
There is an obstacle between the remote control
and the projector.
Remove the obstacle.
You are too far away from the projector. Stand within 8 meters (26 feet) of the projector.
Cause Remedy
You do not remember the password.
Please see "Entering the password recall procedure" on page 23
for details.
Cause Remedy
LAN control settings or LAN cable connection are
problematic.
Verify the LAN control settings. Please see "Configuring the LAN
Control Settings" on page 36 for details. Make sure the LAN
cables are properly connected.
The web page is not shown in the web browser or
the web page is not responding.
Reload the page to see the data after changing on the screen. If
the page is not showing the modified data, check the IP address
of projector and log-in again.
54


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Mitsubishi EX321U-ST at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Mitsubishi EX321U-ST in the language / languages: English as an attachment in your email.

The manual is 1,64 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info