620441
12
Zoom out
Zoom in
Previous page
1/30
Next page
6
Series
1
en
Getting to know your dash cam .................................................................................................... 2
Power button ..............................................................................................................................3
Event button ............................................................................................................................... 3
LED indicators .............................................................................................................................3
Setting up the device .......................................................................................................................4
Using your recorder in a vehicle ..............................................................................................4
Inserting a memory card........................................................................................................... 7
Connecting to your computer .................................................................................................8
Operating basics ...............................................................................................................................9
Turning the recorder on ............................................................................................................9
Restarting the recorder .............................................................................................................9
Function keys ............................................................................................................................10
System icons .............................................................................................................................10
Switching screens ......................................................................................................................11
Setting the date and time ........................................................................................................11
Recording in driving mode ...................................................................................................... 12
Recording in Parking mode ..................................................................................................... 12
Camera mode ........................................................................................................................... 13
Playback mode .........................................................................................................................14
Safety camera alerts ...................................................................................................................... 15
Adding a safety camera ..........................................................................................................16
Updating safety camera data ................................................................................................16
System settings .............................................................................................................................. 17
MiVue Manager ..............................................................................................................................21
Installing MiVue Manager ...................................................................................................... 21
Playing the recording files ...................................................................................................... 21
For more information ....................................................................................................................24
Caring for your device .............................................................................................................24
Precautions and notices ..........................................................................................................25
Safety precautions ...................................................................................................................25
About GPS .................................................................................................................................26
Regulatory information ..........................................................................................................27
WEEE ..........................................................................................................................................28
Table of Contents
2
en
Getting to know your dash cam
Note: The screenshots and other presentations shown in this manual may differ from the
ones generated by the actual product.
1
Power button
2
Device mount socket
3
Mini-USB connector
4
System indicator
5
Event button
6
LCD screen
7
Microphone
8
Memory card slot
9
Camera lens
10
Speaker
11
Parking indicator
12
Function keys
13
Mounting pad
14
Camera lens
15
Fixing bolt
16
Micro-USB connector
3
en
Power button
Press and hold for 2 seconds to manually turn the
recorder on and off.
When the recorder is turned on, press to switch the
LCD screen on and off.
Event button
Press to manually start an event recording.
LED indicators
System indicator
Glows in green when the recorder is charging. During charging, the LED flashes in green
and amber alternately while the recording is in progress.
Parking indicator
Flashes in red when Parking recording is in progress.
4
en
Setting up the device
Using your recorder in a vehicle
Note:
To ensure the highest quality recordings you are advised to place the recorder near
the rear view mirror.
Select an appropriate location for mounting the device in a vehicle. Never place the
device where the driver’s field of vision is blocked.
If the car’s windscreen is tinted with a reflective coating it may be athermic and
impact the GPS reception. In this instance please mount your device where there is a
“clear area.
The system will automatically calibrate the G sensor of the device during start-up.
To avoid G sensor malfunction always turn the device on AFTER you mount it in the
vehicle properly.
Make sure that your car is parked on level ground. Follow the instructions to securely mount
your recorder and rear camera into a vehicle.
1. Mount the recorder.
5
en
2. Mount the rear camera.
Before sticking the mounting pad, you are recommended to clean the windscreen with
rubbing alcohol.
Note: If the adhesion of the adhesive tape does not perform well, replace the tape
with a new one.
3. Adjust the lens angle.
When adjusting the angle of mounting make sure that the camera’s view is parallel with
the level ground and the ground/sky ratio is close to 6/4.
Recorder Rear camera
6
en
4. Connect the cables.
Route the cables through the top ceiling and the A-pillar so that it does not interfere
with driving. Make sure that the cable installation does not interfere with the vehicle's
airbags or other safety features.
Car charger
Recorder 7-metre cable
Rear camera
Y-cable
Note:
If you only use the recorder (without connecting the rear camera) in your vehicle,
simply connect the car charger to the recorder and then plug it to the cigarette
lighter.
The installation illustrations are for your reference only. The placement of the
devices and cables may vary depending on the vehicle model. If you encounter
any problems during installation, contact a skilled installer (such as the service
personnel of the vehicle) for assistance.
7
en
Inserting a memory card
You must insert a memory card (not supplied) before you can start recording. The recorder
supports memory cards with up to 128GB capacity.
1. Hold the card by the edges and gently insert it into the slot with the label facing the rear
side of the recorder.
2. To remove a card gently push the top edge of the card inwards to release it and pull it
out of the slot.
Note:
DO NOT apply pressure to the centre of the memory card.
You are advised to use a Class 10 memory card with at least 8GB capacity.
MiTAC does not guarantee the product’s compatibility with memory cards from all
manufacturers.
Before you start recording please format the memory card to avoid malfunction
caused by files not created by the recorder.
You are recommended to turn the device off before removing the memory card.
8
en
Connecting to your computer
You can connect the recorder to your computer to access data on the memory card. Follow
the instruction below to connect the recorder to the computer via the USB cable (not
supplied).
9
en
Operating basics
Turning the recorder on
Complete the installation according to the instructions in the “Using your recorder in a
vehicle” section. Once the vehicle engine is started the recorder automatically turns on.
Restarting the recorder
Occasionally you may need to perform a hardware reset when the recorder stops
responding or if it appears to be “frozen” or unresponsive. To restart the recorder press and
hold the Power button until the system is shut down; press the Power button again to turn
the recorder on.
Note: If the system does not shut down by keeping the Power button pressed you can
force it to shut down by inserting a small rod (such as a straightened paperclip) into the
Shutdown button on the top of the device.
Shutdown button
10
en
Function keys
The device provides four function keys to control the corresponding icons displayed on the
LCD screen. The key’s function may vary on different screens.
Example 1. Recording screen
Takes a photo
Enters Parking mode
Adds a custom safety (speed) camera
Opens the Menu screen
Example 2. Menu screen
Moves to the next option
Acts as the ENTER button
Moves to the previous option
Acts as the BACK button
System icons
Various System icons on the title bar at the top of the screen provide the status information
of your device. The icons displayed will vary depending on your device model and state.
1
Recording indicator
2
Time display
3
Recording with sound is disabled
4
GPS signal
5
Battery power
6
Your current speed
6
1 2 4 53
11
en
Switching screens
Once you connect the rear camera and start recording, the screen displays the PIP (picture-
in-picture) mode. You can switch the front and rear camera images by pressing .
Note: The video files recorded by the front and rear cameras will be saved separately in
the corresponding folders of the memory card.
Setting the date and time
To make sure that the date and time of your recordings are correct, check the settings before
you begin recording.
1. Press to access the Settings Menu.
2. Select System > Date / Time and press .
3. Select Use GPS time or Manual:
When you select Use GPS time the system will set date and time according to the
GPS location.
When you select Manual the system will display the date and time setting screen.
Use / to adjust the value of the selected field; press and repeat the
step until all fields have been changed. When completed, press .
12


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Mio Mivue 698 Dual at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Mio Mivue 698 Dual in the language / languages: English as an attachment in your email.

The manual is 1,12 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Mio Mivue 698 Dual

Mio Mivue 698 Dual User Manual - German - 31 pages

Mio Mivue 698 Dual User Manual - Dutch - 30 pages

Mio Mivue 698 Dual User Manual - French - 31 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info