REMOTE-CONTROL (optional)
59
CONTINUOUS-DRIVE MODE
58
1. Press the drive-mode
button until appears
in the data panel.
In this mode, the camera continues to release the shutter and
advance the film as long as the shutter-release button is held
down.
2. Press the shutter-release
button down and hold.
• When taking flash pictures, the shutter will release after the
flash is charged.
• When the subject is moving, the shutter will release after the
camera focuses on the subject.
• To cancel continuous-drive mode, press the continuous-drive
mode button until the drive-mode indicator disappears from the
data panel, or turn the camera off.
1. Place the camera on a
tripod, then press the
remote-control button
until appears in the
data panel.
The IR Remote Control RC-3 is an optional accessory you
can purchase to operate your camera from up to 6 m (19.7ft.)
away.
2. Arrange the camera and
subject positions, then
compose your picture.
3. Point the emitter window
toward the front of the
camera and press the • or
2s button.
• If the • button is pressed, the lamp on the front of the camera
will blink once before the picture is taken.
• If the 2s button is pressed, the lamp on the front of the camera
will blink for two seconds before the shutter releases.
Emitter window
2s delay button
Release button
