2120
CHECKING THE BATTERY POWER
Your camera is equipped with an automatic battery-power indicator. Each time the main
switch is turned on, a symbol will appear in the data panel to indicate the power status of the
batteries. It is recommended that you always carry spare batteries in your camera bag.
If no display appears, replace the batteries or check that they are inserted
correctly.
If the blinking low-battery symbol appears in the data panel with the other
indicators, you can still use the camera, but the batteries will need to be replaced
soon.
If the blinking low-battery symbol appears alone; the shutter will lock until the
batteries are replaced.
The full-battery symbol indicates that power is sufficient for all camera
operations.
• To save power, your camera will automatically shut off if it is not operated for more than three minutes.
INSTALLING THE BATTERY
Your camera uses two 3-volt CR2 batteries to supply power for
all camera operations. Please read all warnings in the Safety
Cautions section of this manual as well as those supplied by
the battery manufacturer.
1. Using a coin, open the battery-chamber door as shown.
• Before removing the old battery, turn the camera off.
• Remove dirt and moisture from the camera and battery before
opening the battery chamber cover.
2. Insert the batteries into the chamber as indicated by the
+ and - marks.
3. Snap the battery-chamber door shut.
• If the battery-chamber cover is not closed correctly, moisture may
enter the camera.
• After installing a new battery,-- -- -- will blink in the display, reset the
date and time. See page 65.
