554049
41
Zoom out
Zoom in
Previous page
1/56
Next page
Installation and connection
41
Installation
Make sure the dryer door can be
opened without hindrance after in‐
stallation.
The cool air intake panel at the
front of the dryer must not be
blocked or covered, e.g. by a laun‐
dry basket, as this would cause a
fault.
Building under a continuous work‐
top/in a row of kitchen units
It is very important to avoid a
build-up of heat. The warm air which
is expelled from the rear of the dryer
must be able to dissipate. Warm air
which cannot dissipate could cause
a fault.
N.B. When built under, drying times
may be longer.
A build-up of heat can be avoided by:
Adjusting the screw feet so that there
is a gap of at least 20 mm between
the floor and the bottom of the dryer.
Creating a gap for the dryer in the
kitchen furniture plinth facing.
Creating ventilation gaps in the kitch‐
en unit.
The dryer should not be installed
next to a refrigeration appliance. The
warm air expelled from the rear of
the dryer would increase the temper‐
ature around the refrigeration appli‐
ance's heat exchanger causing the
compressor to run continuously. If it
is not possible to install the dryer
anywhere else, then the refrigeration
appliance must be sealed off from
the dryer.
Building under kits must only be
installed/dismantled by a suitably
qualified fitter.
A special building under conversion
kit* with a cover plate to replace the
appliance lid is required. It must be
fitted by a suitably qualified fitter to
ensure electrical safety. N.B. If there
is space to push the tumble dryer un‐
der the worktop without removing the
lid, the building under kit is not nec‐
essary. Otherwise it is essential.
Fitting instructions are supplied with
the conversion kit.
The electrical socket must be located
in an accessible position near the ap‐
pliance.
With niche heights of:
830-840 mm, longer screw feet* are
required.
870-885 / 915-930 mm, one or two
raising kits* are required.
*Miele accessory available to order
41


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Miele T 8164 WP at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Miele T 8164 WP in the language / languages: English as an attachment in your email.

The manual is 1,41 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Miele T 8164 WP

Miele T 8164 WP User Manual - German - 56 pages

Miele T 8164 WP User Manual - Dutch - 56 pages

Miele T 8164 WP User Manual - French - 56 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info