Midland G9 PRO instruction guide | 13
Displaying the channel/sub audio tone
To momentarily display the PMR446 channel and the subadio tone used in
the pre-set channels, go to the desired channel (from 9p to 24p - traditional
band) or from 17p to 32p (new band) and keep pressed the ▼ for 3 seconds.
Transmission and reception
To transmit keep the PTT button firmly pressed (it is not important what part of
it). Wait for a fraction of a second then speak normally in the direction of the
microphone; TX will appear on the display.
When you have finished, release the PTT.
When the radio is in reception mode (PTT released) you will automatically re-
ceive any communication. RX will be displayed.
By default the output power set is “H-high”, so independently on which
PTT key you press (small or big)the transmission will be with high power.
If you use an external microphone, the PTT on it will follow the same PTT setting
of the radio.
Transmitting TOT Setting
The TOT function is used to prevent a too long transmission. This function
temporarily blocks transmissions if the radio has been used beyond the
maximum time permitted. Once reached the preset timer, the radio will be
forced in reception mode.
VOLUME adjustment
Rotate the VOLUME knob till you reach the desired level.
“CALL”
Push the CALL button and you will send an audio signal to the users tuned on
the same channel; you can choose amongst dierent CALL tones.
“Emergency”
When the Emergency function is enabled (+ blinks on the display) keep pres-
sed +/EMG for 3 seconds and you send an emergency call to the other G9
PRO within your range.
The Emergency function is activated by default.
