579673
11
Zoom out
Zoom in
Previous page
1/54
Next page



Rotate the clockwise to turn the radio on.
Rotate the control clockwise /counter-clockwise to adjust the volume level as
you prefer.
Rotate the control counter-clockwise till hearing a mechanical “click”, to turn
the radio off.

To communicate, all radios in your group must be set to the same channel.
Briey press the  to enable the Monitor feature in order to
make sure that the frequency is not busy, then press the button.
For a maximum clarity, hold the device at a distance of about 4/10 cm.
Release the key to receive.
Only one user at a time can talk during radio communications. Therefore,
it is important not to transmit when you are receiving a communication and
use the transmission mode sparingly to allow other users to use the feature.
Transmission consumes a signicant amount of energy and should therefore
be used sparingly to prolong the battery life.
If you are unable to contact a station that you have no problems in receiving,
the station may be using CTCSS tones or DCS codes.

The Monitor feature is for temporarily excluding (opening) the Squelch, in
order to listen to signals that are too weak to keep the Squelch permanently
opened.
Briey press the  to enable such function.

Keep pressed the for about 4 sec. to enable the  fun-
ction: the radio will scan all channels from the channel in use.
Whenever any signal is detected, the radio will suspend the Scan; to resume
scanning, press again the 

enables hands free conversations through the VOX function: just speak
in the direction of the microphone and the communication will be automati-
cally activated.
The VOX sensitivity can be adjusted in 10 different levels () trough
the programming software:
0 means that the VOX is turned off, 1 is the lowest VOX sensitivity level and
9 is the highest one.
By default, the VOXsensitivity of  is set on level 5.
To activate the VOX feature, keep pressed for about 4 sec. the 


The Squelch function suppresses noises on free channels and allows to re-
ceive even weak signals.
 has 10 different Squelch levels settable by programming software: 0
means that the Squelch is turned off; from level 1 to level 9 you will have
different levels of noise reduction. The higher is the level, the louder will be
the Squelch.
By default, the Squelch level of  is set on level 5.
Make sure you do not set an excessively high squelch level because in this
case you may not be able to receive weaker signals. On the other hand an
excessively low Squelch value could enable the Squelch even when no si-
gnals are present.
Squelch must always be adjusted when no signals are present.
The Time Out timer is settable from 30 sec to 270 sec. only through the pro-
gramming software.
This feature is disabled by default.

When the  button is released, the radio will beep to conrm to other users
that you’ve nished your transmission and that they can begin to speak.

This function permit you to produce a beep tone every time you press a button.
11


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Midland G11-S at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Midland G11-S in the language / languages: English, German, Dutch, French, Italian, Portuguese, Spanish as an attachment in your email.

The manual is 4,55 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info