543219
5
Zoom out
Zoom in
Previous page
1/12
Next page
The set is being operated with 3 x AAA size Alkaline or rechargeable NiCd/ NiMH batteries independent
from vehicle power supply (not supplied with the intercom).
Declaration of Conformity:
The motorbike communication system fits in conformity with the European EMC directive
2004/108/EG, European EMC standards EN 50 022:2006, EN 55024:1998 with A1 and A2 (2003),
EN 60065: 2002 + A1 (2006) (electrical safety) and WEEE / RoHS, and it carries the CE- mark. The
actual EC declaration of conformity can be downloaded from www.hobbyradio.de
Conditions for accessory connection
MP-3/Music CD or Navigator voice announcements:
3.5 mm stereo plug (3). To enjoy music in stereo is not possible, the ear-phones get the same signal (mono).
The volume is adjustable by the volume control
(4)
.
Hints for installation and connection
Fitting of helmet sets:
The two helmet sets consist of two flat padded ear sets to be inserted in the helmet, a microphone with a
flexible thin boom to be installed close to your mouth and a waterproof transmit talk button which can be
fixed within reach of the handle-bar or at your glove.
Supplied are two self-adhesive pads for fitting the earphones in the helmet and a velcro tape adjustable in
length to install the talk button. These adhesive pads do have an adhesive surface on one side (remove
protective foil), on the other side there is a velcro clasp so that ear sets can be easily installed or removed for
adjustment or cleaning. Bikers with only limited space to install the talk button i. e. on a metal plate at the
handle bars may remove the velcro tape and stick the talk button with adhesive pads directly to the desired
location.
Please fix the ear sets with still a small gap between the ears and the helmet. Your ears should not be
completely covered by the ear set because then you might not be able to listen to the surrounding noise of
traffic (due to Road Traffic Act you may not use headsets that completely cover your ears because you
might overhear honking or other signals).
Please do not carry out any technical modifications at the helmet before installing the headset. The ECE
standard for motorbike helmets does not permit to flatten the material inside the helmet i. e. to make space
for the ear set. Fix the microphone so, that it is always close to your mouth with the supplied adhesive pad.
Before fixing the adhesive pads thoroughly clean the desired location (i.e. with alcohol, but do not use any
solvent). Press tightly and remember that it takes several hours until the final strength has been achieved.
The basic installation is very simple- just plug in the 2 headphones (2), and that’s it!
Where to locate the central unit
The best place for location of the central unit is inside or close to the tank knap sack or in the outside-pocket
of your biker-suit.
Power supply / Inserting of batteries
Open the battery lid at the bottom of the central unit. Insert 3 batteries or rechargeable batteries size AAA
(Micro). Pay attention to the correct position of the battery poles.
Warning:
Never use batteries and rechargeable batteries mixed in the battery compartment. Only use batteries
or rechargeable batteries of the same kind, and never mix full and empty batteries. Dispose of used
batteries only at the authorized collecting points at special dealers. Pay attention to the different
containers for batteries and rechargeable batteries. Batteries and rechargeable batteries are special
waste, they may not be disposed of with household garbage. Never throw batteries or rechargeable
batteries into any fire, never short-circuit the poles of batteries or rechargeable batteries: Danger of
fire, explosion or injury may occur!
5


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Midland Albrecht AE600 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Midland Albrecht AE600 in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 1 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info