622039
21
Zoom out
Zoom in
Previous page
1/26
Next page
18
English
8.5.a Table of solutions
Problem Possible cause Solution
The radio doesn't switch on The battery pack is discharged and/or has not been
installed correctly.
Verify that the battery pack is charged and that it has been
correctly installed.
The radio switches off shortly
after it has been switched on
Discharged battery pack. Recharge the battery pack.
The battery pack does not
recharge
The battery-charger has not been connected or
installed correctly.
Inspect the connections of the battery-charger and the
installation of the batteries.
The radio switches on but is
unable to receive signals
The site of installation is too shielded. Move to an another area.
The volume is too low Adjust the volume.
Incorrect CTCSS or DCS Check that the CTCSS tone or DCS code corresponds to the
one set by the parties you are communicating with.
Noise is always present in
reception mode
The monitoring function is enabled. Disable the monitoring function.
It is not possible to
communicate with other parties
An incorrect radio channel has been selected. Select the same radio channel used by the parties you are
communicating with.
The radio is installed in a shielded area or is too far
from the party you are communicating with
Move to another area.
Incorrect CTCSS or DCS Check that the CTCSS tone or DCS code corresponds to the
one set by the parties you are communicating with.
Reception is fragmented and/or
disturbed
The signal is very weak. Try temporarily disabling the squelch by means of the
Monitoring feature.
The transmission distance is excessive and/or there
are obstacles in the transmission path
Move closer to the party you are communicating with or to
another area.
Other parties are using the same channel Checkthetrafcontheradiochannelbymeansofthe
Monitoring feature and select another channel if required.
The radio has been installed too close to equipment
that causes interference (televisions, computers, etc.)
Increase the distance between the radio and this equipment.
Received communications are
not clear
Thescramblerhasbeenconguredonadifferent
setting as compared to that of the parties you are
communicating with (all the parties should either
enable or disable the scambler).
Select the same scrambler setting of the parties you are
communicating with.
21


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Midland Alan HP450 2A Rugged at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Midland Alan HP450 2A Rugged in the language / languages: English as an attachment in your email.

The manual is 1,92 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Midland Alan HP450 2A Rugged

Midland Alan HP450 2A Rugged User Manual - German - 29 pages

Midland Alan HP450 2A Rugged User Manual - French - 27 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info