or press the o keys to begin channel scanning again.
• If the communication is of interest to you, you can halt scanning
by briey pressing the or PTT buttons.
4. To exit the scanning mode and return to Stand-by on the currently
selected channel, press the
button, or press the F button to
access the following menu setting.
Scanning can only be executed on commonly-used channels . For
further details, refer to par. 6.4.c.
6.3.b Activating Dual Watch
The Dual Watch function allows you to monitor two channels of your
choice at the same time by executing a scan on the two channels. To
select the Dual Watch function, follow the steps outlined below:
1. First, select a channel.
2. Repeatedly press the
F key until the DW icon ashes on the
display.
3. Using the
and buttons, select a second channel that you wish
to scan. After approx. one second, the transceiver will begin to
execute a scan on the two channels.
4. When the transceiver detects a transmission on one of the two
channels, Dual Watch temporarily pauses, remaining tuned for 5
seconds on the corresponding channel, giving the user a chance
to respond to a call. After this pause, the transceiver begins
scanning again.
5. If Dual Watch pauses on a channel on which you would like to
send a transmission, press the
PTT button. This will deactivate
Dual Watch, allowing you to communicate normally. To reactivate
Dual Watch, follow the steps outlined above.
6. To exit Dual Watch mode and return to normal reception on the
currently selected channel, press the
button, or press the F
button to access the following menu setting.
6.4 Memory channels
The transceiver is equipped with 20 memories (from 01 to 20) into
which commonly-used channels can be saved. Once stored, these
channels can rapidly be recalled and scanned.
6.4.a Programming of memory channels
To store channels in the memories, follow the steps outlined below:
1. Repeatedly press the
F key until the Mem icon ashes on the
display below the small memory number (from 01 to 20). The
channel currently selected will also begin to ash (large numbers).
Press the
o buttons to select the memory number desired.
2. Press the
F button again. Only the Mem icon and the band icons
will ash.
3. Press the
o buttons to select the channel you want to store.
4. Push the
F button again to select a CTCSS tone. The number of
this tone will blink on the display.
5. Press the
o buttons to select the CTCSS tone you want to
store.
6. Press the
button to conrm your selection.
Now it is possible to:
• program another channel - by repeating steps 1 to 6.
• access the following menu setting –by pressing the
F button
7. Push
to return to stand-by mode.
6.4.b Memory recall
To select a stored channel, follow the steps outlined below:
1. Repeatedly press the
F key until the small memory number
(from 01 to 20) and corresponding stored channel appear on the
display.
2. The digit indicating the memory can either be xed on the display
or can blink. In the former case, it means that the memory is
occupied by the channel displayed, in the latter case it means that
