Manual Midas VeniceF F16 (page 123 of 130) (English)

658475

123

Zoom out

Zoom in

1/130

XLR shells 111

VeniceF

Operator Manual

XLR shells

XLR pin 1s should only be used to provide a ground connection for cable screens. The

shell (body) of cable XLRs also need to be connected to ground so they provide a screen

for the terminals, but they should not be wired internally to the pin 1 terminal. Their

ground should be prevented from contact with the panel XLR connector body. This is

particularly important for unbalanced connections where an internal connection from

pin 1 to the connector shell could compromise ground lifting schemes. With this wiring

arrangement, joining XLR cables together to increase the overall length is best avoided,

because the joint will not be properly screened. However, if absolutely necessary it is

unlikely to cause major problems.

Signal ground bonding

If an unbalanced connection is required to external equipment with signal grounds that

cannot be isolated from safety earth it will be difficult to eliminate ground loop currents,

but their effects can usually be reduced. The currents within a ground loop will

generate small voltages in the cables, including the signal grounds. Any voltages that

develop in the signal grounds will appear as noise errors in the audio. If the impedance

of the screen cables is reduced, the voltage developed by the ground loop will also be

reduced. So, if the impedance can be zero there will be no noise. This is difficult to

achieve, but ground bonding the external equipment rack to the chassis of the VeniceF

will have a similar effect and will significantly reduce noise in unbalanced connections

between the two locations. A binding post chassis ground is provided on the VeniceF

for this purpose.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Midas VeniceF F16 in the language / languages: English as an attachment in your email.

The manual is 3,96 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Midas VeniceF F16 Manual

Product: