783952
5
Zoom out
Zoom in
Previous page
1/16
Next page
4
5
(aufwärts, abwärts oder quer) versuchen und den Scherkopf gegen
die Wuchsrichtung bewegen.
Für das beste Ergebnis auf vollständig trockener Haut und
Haaren benutzen.
PRÄZISES TRIMMEN OHNE AUFSATZ
Eine der beiden Kanten der Klinge für scharfe Linien nutzen.
Halten Sie den MicroTouch Solo Titanium mit der Klinge an die
Haut, so dass nur eine Kante tatsächlich die Haut berührt (Bild 7).
Mit sanften & leichten Bewegungen den Bart zurechtschneiden.
PFLEGE UND WARTUNG
Reinigung:
Die MicroTouch Solo Titanium Klinge ist zerbrechlich – bitte mit
Sorgfalt handhaben.
Wenn sich Haare am Aufsatz oder der Klinge angesammelt
haben, vorsichtig mit der mitgelieferten Bürste reinigen.
Die Klinge nicht spülen. Das kann Schäden verursachen.
Entfernen des Trimmaufsatzes:
Den Daumen oben auf den Trimmaufsatz legen (Bild 8) und nach
unten drücken, um diesen vom Klingenkopf (Bild 9) zu entfernen.
Heben Sie den Trimmaufsatz ab (Bild 10).
Anbringen der Trimmaufsatzes
Achten Sie bitte darauf, den gewünschten Aufsatz mittig zu platzieren
und durch leichtes Andrücken auf beiden Breitseiten mit je einem
Klick einrasten zu lassen. (Bild 12)
Tauschen der Klinge:
Für optimale Ergebnisse, die Klinge alle 1-2 Monate oder, sobald
diese nicht mehr die gewünschten Ergebnisse erzielt, ersetzen.
Alle Zubehörteile entfernen.
Bei aufgesetzter Abdeckung die Klingenfreigabe vorsichtig nach
oben schieben und die Klinge entfernen (Bild 11).
Die neue Klinge seitlich halten und auf das Griffstück drücken,
bis ein “Klick” zu hören ist.
Die Abdeckung vor Gebrauch entfernen.
HINWEIS: Darauf achten, dass der Schaft unter dem Klingenkopf
in der Mitte sitzt, bevor diese einrastet. Wenn sich die Klinge nach
dem Austausch nicht bewegt, sobald das Gerät eingeschaltet ist, die
Klinge abnehmen, das Gerät ohne Klinge kurz einschalten und diese
erneut, wie beschrieben, anbringen.
EN
WARNING NOTES
Only for dry use.
Do not rinse Only ever clean the blade using
the supplied brush.
Keep out of the reach of children.
Do not place in water or other liquids while
the device is being charged.
Do not submerge into water or other liquid.
Unplug and remove power cord before
cleaning/using.
Do not use the trimmer while it is plugged in.
This unit contains a lithium ion battery.
Dispose of in accordance with all applicable
federal, state and local regulations.
Do not dispose of in fire.
Do not use your MicroTouch Solo Titanium on
sensitive or irritated skin.
Always check the unit before use. Do not use
if damaged, as personal injury may occur.
This appliance can only be used by
children aged from 8 years and above and
persons with reduced physical, sensory or
mental capabilities or lack of experience
and knowledge if they have been given
supervision or instruction concerning use of
the appliance in a safe way and understand
the hazards involved.
GETTING STARTED
NOTE: Prior to first use, test the blade on a small area of your arm
or leg. If hypersensitivity or an allergic reaction occurs, discontinue
use immediately. Use with care around sensitive areas, such as the
ears, to avoid scratches and cuts.
CHARGING
Ensure that the unit is fully charged before use.
Plug the small end of the charging cable into the MicroTouch Solo
Titanium and the large end into a USB port (Figure 1) (Adapter not
included). Initial charging and recharging requires approximately
4 hours.
The power indicator LED will turn RED when charging (Figure 2).
The light will switch off as soon as the device is fully charged.
The MicroTouch Solo Titanium has an operating time of
approximately 45 minutes when fully charged.
NOTE: If the performance weakens, recharge the device.
APPLICATION
The MicroTouch Solo Titanium is intended for use on facial hair
including beards, moustaches and sideburns.
The MicroTouch Solo Titanium is designed for DRY USE ONLY. Do
not use in shower.
If the blade cover is attached, slide it down before use (Figure 3).
Use the On/Off switch to turn MicroTouch Solo Titanium ON and
OFF (Figure 4).
NOTE: When the appliance is turned on, the power indicator LED
turns blue. It is recommended that the blade cover be kept on when
the appliance is not in use.
SHAVING
DO NOT use water and/or shaving foam. This can cause the blade
to stick or to stop working.
Hold the surface of the blade against your skin
(Figure 5).
For best results, move the shaver head in the opposite direction
of hair growth. Press lightly while making long strokes.
NOTE: It is normal for the shaving head to become warm during use.
M29228_MicroTouchTitaniumSolo_Manual_A5_20210923_CP.indd 5M29228_MicroTouchTitaniumSolo_Manual_A5_20210923_CP.indd 5 23.09.21 10:5523.09.21 10:55
5


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for MicroTouch Titanium Solo at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of MicroTouch Titanium Solo in the language / languages: English, German, Dutch, French, Italian as an attachment in your email.

The manual is 1.37 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info