Manual Microlife BP A50 (page 6 of 105) (English, German, Dutch, French, Polish, Portuguese, Turkish, Spanish)

536835

Zoom out

Zoom in

1/105

4. Appearance of the Heart Arrhythmia Indicator for

early Detection

This symbol AM indicates that certain pulse irregularities were

detected during the measurement. In this case, the result may

deviate from your normal blood pressure – repeat the measure-

ment. In most cases, this is no cause for concern. However, if the

symbol appears on a regular basis (e.g. several times a week with

measurements taken daily) we advise you to tell your doctor.

Please show your doctor the following explanation:

5. Data Memory

At the end of each measurement, this instrument automatically

stores the result.

Viewing the stored values

Press the M-button 3 briefly, when the instrument is switched

off. The display first shows the last stored result.

Pressing the M-button again displays the previous value. Pressing

the M-button repeatedly enables you to move from one stored

value to another.

Memory full

Clearing all values

6. Battery Indicator and Battery change

Low battery

When the batteries are approximately ¾ empty the battery symbol

AO will flash as soon as the instrument is switched on (partly filled

battery displayed). Although the instrument will continue to

measure reliably, you should obtain replacement batteries.

Flat battery – replacement

When the batteries are flat, the battery symbol AO will flash as

soon as the instrument is switched on (flat battery displayed). You

cannot take any further measurements and must replace the

batteries.

Which batteries and which procedure?

Using rechargeable batteries

You can also operate this instrument using rechargeable batteries.

During the measurement, the heart symbol

flashes in the

display and a beep sounds every time a heartbeat is detected.

10.

The result, comprising the systolic

and the diastolic

blood pressure and the pulse

is displayed and longer beep

is heard. Note also the explanations on further displays in this

booklet.

11. When the measurement has finished, press the quick-acting

discharge valve 6 in order to release any remaining air in

the cuff. Remove the cuff.

12. Switch off the instrument. (The monitor does switch off auto-

matically after approx. 1 min.).

)

You can interrupt the measurement at any time by pressing

the quick-acting discharge valve 6 (e.g. if you feel uneasy

or notice an unpleasant pressure sensation).

Information for the doctor on frequent appearance of the

Arrhythmia indicator

This instrument is an oscillometric blood pressure monitor that

also analyses pulse frequency during measurement. The instru-

ment is clinically tested.

The arrhythmia symbol is displayed after the measurement, if pulse

irregularities occur during measurement. If the symbol appears

more frequently (e.g. several times per week on measurements

performed daily) we recommend the patient to seek medical advice.

The instrument does not replace a cardiac examination, but

serves to detect pulse irregularities at an early stage.

When the memory has stored 14 results, the memory is full.

From this point onwards, a new measured value is stored by

overwriting the oldest value.

All memory data are cleared when batteries are taken out

of the instrument.

1. Open the battery compartment 7 at the back of the instrument.

2. Replace the batteries – ensure correct polarity as shown by the

symbols in the compartment.

)

Use 2 new, long-life 1.5V, size AAA batteries.

)

Do not use batteries beyond their date of expiry.

)

Remove batteries if the instrument is not going to be used

for a prolonged period.

)

Only use «NiMH» type reusable batteries.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Microlife BP A50 in the language / languages: English, German, Dutch, French, Polish, Portuguese, Turkish, Spanish as an attachment in your email.

The manual is 4,72 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Microlife BP A50 Manual

Product: