Manual Microlife BP A130 (page 6 of 48) (English, Italian, Turkish)

536800

Zoom out

Zoom in

1/48

4. Appearance of the Heart Arrhythmia Indicator for

early Detection

This symbol AQ indicates that certain pulse irregularities were

detected during the measurement. In this case, the result may

deviate from your normal blood pressure – repeat the measure-

ment. In most cases, this is no cause for concern. However, if the

symbol appears on a regular basis (e.g. several times a week with

measurements taken daily) we advise you to tell your doctor.

Please show your doctor the following explanation:

5. Traffic Light Indication in the Display

The bars on the left-hand edge of the traffic light display BT show

you the range within which the indicated blood pressure value lies.

Depending on the height of the bar, the readout value is either

within the normal (green), borderline (yellow) or danger (red)

range. The classification corresponds to the 6 ranges in the Table

as defined by the WHO, as described in «Section 1.».

6. Data Memory

At the end of each measurement, this instrument automatically

stores the result, including date and time.

Viewing the stored values

Press the M-button AT briefly, when the instrument is switched

off. The display first shows «M» AP and then a value, e.g. «M 17».

This means that there are 17 values in the memory. The instrument

then switches to the last stored result.

2. Sit down for at least 5 minutes before the measurement and

relax.

3. Always measure on the same arm (normally left).

4. Remove close-fitting garments from the upper arm. To avoid

constriction, shirt sleeves should not be rolled up - they do

not interfere with the cuff if they are laid flat.

5. Always ensure the cuff is positioned correctly, as shown on

the cuff.

• Fit the cuff closely, but not too tight.

• Make sure that the cuff is 2 cm (0.75 inch) above your

elbow with the tube on the inside of your arm.

• Support your arm so it is relaxed.

• Ensure that the cuff is at the same height as your heart.

6. Press the ON/OFF button 1 to start the measurement.

7. The cuff will now pump up automatically. Relax, do not move

and do not tense your arm muscles until the measurement

result is displayed. Breathe normally and do not talk.

8. When the correct pressure is reached, the pumping stops

and the pressure falls gradually. If the required pressure was

not reached, the instrument will automatically pump some

more air into the cuff.

During the measurement, the heart symbol

flashes in the

display and a beep sounds every time a heartbeat is detected.

10. The result, comprising the systolic AM and the diastolic AN

blood pressure and the pulse AO is displayed and longer

beep is heard. At the same time, the blood pressure monitor

will announce the result. Note also the explanations on

further displays in this booklet.

11. When the measurement has finished, remove the cuff.

12. Switch off the instrument. (The monitor does switch off auto-

matically after approx. 3 min.).

)

You can stop the measurement at any time by pressing the

ON/OFF button (e.g. if you feel uneasy or an unpleasant

pressure sensation).

Information for the doctor on frequent appearance of the

Arrhythmia indicator

This instrument is an oscillometric blood pressure monitor that

also analyses pulse frequency during measurement. The instru-

ment is clinically tested.

The arrhythmia symbol is displayed after the measurement, if

pulse irregularities occur during measurement. If the symbol

appears more frequently (e.g. several times per week on

measurements performed daily) we recommend the patient to

seek medical advice.

The instrument does not replace a cardiac examination, but

serves to detect pulse irregularities at an early stage.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Microlife BP A130 in the language / languages: English, Italian, Turkish as an attachment in your email.

The manual is 3,74 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Microlife BP A130 Manual

Product: