Charging the accumulator
• IMPORTANT!! Put the On/Off switch in „0“ Position (off) (Fig. 1).
• Plug the adapter to the appliance. Therefore put the small connector into the opening
provided at the appliance (Fig. 2 see page 3).
• Plug the adapter to a mains socket (Fig. 3).
• While charging the charging control lamp will illuminate in red colour. When charging
has finished the charging control lamp will change into green colour.
• Charging time is approximately 12 hours.
While charging the environmental temperature may not be lower than 15° and not
higher than 35°C. Otherwise the lifespan of the accumulator could be impaired.
• If you do not use the appliance for one month, please charge again completely.
To enlarge the accumulator lifespan to its maximum please use the appliance as long
as the accumulators are completely discharged. Then charge again completely.
NOTE: Remove the accumulator if it is damaged only. All repairs or change of
accumulators should be made by a competent qualified after sale service. Never throw
damaged accumulators into the household waste but dispose off in special
accumulator or battery collecting points.
Tips
• This appliance is suited for removal of body hair. (Fig. 4, see page 3). It is suited for
wet and dry shave.
• If your hair is longer than 10 mm you should cut bevor in order to make hair removal
easier. For best result the appliance should always be in contact with the skin.
• Do not use the appliance at wet, long hair. It is suited for short, dry hair. Shaving and
shortening of the hair is much easier when the hair is dry.
• Spend time fort he first body grooming and operate slowly and gently to get used with
the appliance. Act with special care in sensitive body areas cause the skin must get
used to the appliance as well.
• Shaving needs practice, never move the appliance quickly through the hair. Never
move the hair clipper quickly through the hair. The appliance works at its best if it is
pushed slowly and gently through the hair along the body.
• If necessary repeat the procedure at uneven area.
Operation
• Ensure that the appliance is in perfect condition and the blade is always slightly oiled.
• It is recommended to wash and dry the heir before hair removal. Then cut the dry hair.
• To get a good shaving result, the hair must be very short already. Shorten the hair with
the blades 12 or 5 if necessary.
• First remove the comb attachment of it is fixed at the appliance (Fig. 5).
• Ensure that the mobile blade 5 is adjusted in cutting length position 0 (Fig. 6).
• Switch on the On/Off switch (Fig. 7).
• Gently press the razor head onto the skin. During the shaving process the razor head
must be always in contact with the skin.
