106
Het instellen voor het laden van een favoriet pro-
gramma
• Toets indrukken, het keuzemenu ver-
schijnt.
• Met de toetsen de opslaglocatie of
selecteren.
• Toets
° indrukken en de gekozen opslagloca-
tie bevestigen.
• Met de toetsen selecteren.
• Toets
° indrukken en het starten van het
favoriete programma bevestigen.
• De o.k verschijnt op het display.
F2F1
LOAD
8 Met de hand in te stellen correctie
op de flitsbelichting
De automatiek van de flitsbelichting is in de meeste
camera’s gebaseerd op een reflectiegraad van 25%
(gemiddelde reflectiegraad van flitsonderwerpen).
Een donkere achtergrond die veel licht absorbeert
of een lichte achtergrond die sterk reflecteert (bijv.
tegenlichtopnamen), kunnen leiden tot te ruim, c.q.
te krap belichte onderwerpen.
Om het bovengenoemde effect te compenseren kan
de flitsbelichting via een met de hand in te stellen
correctiewaarde worden aangepast aan de opname-
situatie.
De hoogte van die correctiewaarde hangt af van het
contrast tussen onderwerp en achtergrond!
Op de flitser kunnen in de TTL-flitsfuncties met de
hand correctiewaarden voor de flitsbelichting van -
3 tot +3 stops (EV) in stappen van 1/3 stop worden
ingesteld.
Tip:
Donker onderwerp tegen een lichte achtergrond:
positieve correctiewaarde.
Licht onderwerp tegen donkere achtergrond:
negatieve correctiewaarde.
Een belichtingscorrectie door veranderen van de
diafragmaopening van het objectief is niet moge-
lijk, omdat de belichtingsautomatiek van de camera
het veranderde diafragma weer als werkdiafragma
ziet. Bij het instellen van een correctiewaarde kan
de aanduiding van de reikwijdte in het display
veranderen en aan de correctiewaarde worden aan-
gepast (hangt af van het type camera)!
F1
LOAD
SAVE