517350
65
Zoom out
Zoom in
Previous page
1/108
Next page
65
ķ
6.1.2 High-speed synchronisation (HSS)
For system-induced reasons, high-speed synchronisation is not supported by
the flash unit.
6.1.3 Cordless REMOTE flash control
For system-induced reasons the cordless REMOTE flash control is not sup-
ported by the flash unit.
6.1.4 Preflash function for red-eye reduction
Various cameras offer the possibility to activate a preflash for red-eye re-
duction. This function only supports the flash unit integrated in the camera. It
does not support external flash units.
7. Optional extras
No guarantee is given for malfunctions and damage to the flash unit
caused by the use of accessories from other manufacturers!
Wide-angle diffuser 44-21
(Item No. 000044217)
For full illumination in conjunction with lenses of 20 mm and up. The range
is reduced by the factor 1.4 due to the corresponding loss of light.
Colour filter set 44-32
(Item No. 00004432A)
Consists of 4 colour filters to achieve special lighting effects, plus a clear fil-
ter to hold colour foils in any colour.
Mecabounce 44-90
(Item No. 000044900)
A diffuser to achieve soft illumination in the simplest possible manner. The
effect is very impressive because the pictures are given a very soft atmos-
phere. Facial colours are rendered more naturally. However, loss of light
halves the maximum flash range.
Bounce diffuser 54-23
(Item No. 000054236)
The soft directed light diminishes dense shadows.
8. Advice in the event of a fault
Should the LC display indicate meaningless information or should the flash
unit not work properly in the individual modes, then switch off the flash unit
for about 10 seconds by its main switch. Check the camera settings and find
out if the flash unit’s foot is correctly mounted in the camera’s accessory shoe.
The flash unit must operate properly when it is switched on again. Contact
your local dealer should this not be the case.
9. Maintenance and care
Remove any grime and dust with a soft, dry or silicon-treated cloth. Never
use detergents that could damage plastic parts.
Forming the flash capacitor
The flash capacitor incorporated in the flash unit undergoes a physical change
when the flash unit is not switched on for prolonged periods of time. For this
reason it is necessary to switch on the flash unit for approx. 10 minutes every
3 months (see 2.4!). The batteries must supply sufficient power for flash readi-
ness to be indicated within 1 minute after the flash unit was switched on.
10. Technical data
Maximal guide number at ISO 100/21°, 105 mm zoom:
In the metric system: 54; In the imperial system: 177
Flash durations:
Approx. 1/200th to 1/20,000th sec. (in TTL mode)
In M mode approx. 1/200th sec. at full light output
At 1/2 light output approx. 1/600th second
At 1/4 light output approx. 1/1,500th second
At 1/8 light output approx. 1/5,000th second
Colour temperature:
approx. 5600 K
54 AF-1 M 03.08.2004 10:53 Uhr Seite 65
65


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Metz MECABLITZ 54 AF-1 Minolta at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Metz MECABLITZ 54 AF-1 Minolta in the language / languages: English, German, Dutch, French, Italian, Spanish as an attachment in your email.

The manual is 1,15 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info