654458

Mettler-Toledo Impact M Compact Scale Manual

11
Zoom out
Zoom in
Previous page
1/138
Next page
Chapter 1: Introduction
Power
1-3
Power
The power switch and power cord jack are located under the touchscreen on the left front
of the scale.
Press on the switch to turn the scale power to ON and again to turn the scale off (it is
a momentary switch, so it will return to its original position after being touched). Always
exit any editing screens before pressing the switch to turn power OFF. Always turn the
scale off before cleaning.
The Impact M requires 100-240 VAC, 50/60 Hz, 2.2A power. Wiring must include a
proper ground. The integrity of the power ground for equipment is important for both
safety and dependable operation of the electronic device. A poor ground can result in an
unsafe condition should an electrical short develop in the equipment.
A good ground connection minimizes extraneous electrical noise pulses. The electronic
device should not share power lines with noise-generating equipment. Examples include
electrical motors, compressors, heating elements, lights, and relays that may generate
noise spikes and power surges. To confirm ground integrity, use a commercial branch
circuit analyzer or grounded outlet tester. If adverse power conditions exist, a dedicated
power circuit or power line conditioner might be required.
Network Connection
The Impact M can connect to your Ethernet network using a cable or using a wireless
radio. If you use a wired network connection and experience connection problems, make
sure your Ethernet cable is connected and seated securely in the jack, located under the
touchscreen at the front of the scale.
If you are using a wireless radio, it is built into the scale under an access panel situated
below the platter and spider on the left-hand side.
If the scale has a wireless card installed, do not connect an external Ethernet cable to the
Ethernet port.
Power
Switch
Power
Cord Jack
Ethernet port
… 11 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Mettler-Toledo Impact M Compact Scale at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Mettler-Toledo Impact M Compact Scale in the language / languages: English as an attachment in your email.

The manual is 11,86 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info