659290
57
Zoom out
Zoom in
Previous page
1/74
Next page
Chapter 4: Labels
Label Requirements
4-7
TOTAL THICKNESS LABEL + ADHESIVE + LINER
Total Thickness Label + Adhesive + Liner: 159 ± 17 μ METER (0.0056 to 0.0069
inch)
LIGHT TRANSMISSION FOR GAP SENSOR OPERATION:
Light transmission at 800 to 900 NM wave length through the liner only must be at
least 3 times the transmission through the liner and label together. This means that the
transmission optical density of the liner must be at least 0.48 less than the that of the
liner and label together.
Light transmission at 800 to 900 NM wave length through the liner and label together
must be at least 2% of incident light. This corresponds to an optical density of 1.7.
Also see OPTICAL DENSITY DEFINITION further in this chapter.
Label Stripping
Labels must strip from the liner over a temperature range of 2°C (26°F) at 50% RH
to 43°C (110°F) at 85% RH.
Finished Label Roll
Requirements
CORE AND METHOD OF LABEL ATTACHMENT
The label stock must not be permanently attached to the cardboard core. The liner must
separate cleanly from the core with 1.0 pound pull tangent to the core as shown in the
figure below. No core material, tape, or adhesive is to remain on the label or liner after
separation. Material, especially hot melt adhesive, remaining on the label will damage
the print head.
DIE CUTTING
Die cutting of the labels must not perforate the release liner.
57


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Mettler-Toledo bPro at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Mettler-Toledo bPro in the language / languages: English as an attachment in your email.

The manual is 2,66 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info