776315
143
Zoom out
Zoom in
Previous page
1/155
Next page
MI 3288 EI Tester Appendix C Functionality and placing of test probes
143
Distance from earthing electrode E/ES to voltage probe S shall be:
( )
Sadd
= 112 38,072,0
In case of a properly selected d1 the result of measurements 2 and 3 are symmetrical around
the result of measurement 1. The differences (measurement 2- measurement 1, measurement
3 - measurement 2) must be lower than 10 %. Higher differences or non-symmetric results
mean that the voltage funnels influence the measurement and the d1 should be increased.
Notes:
Initial uncertainty of measured resistance to earth depends on distance between
electrodes d1 and size of earthing electrode a. It can be seen in Table C.4: Influence of
d1/a ratio to initial uncertainty.
d1/a
Uncertainty
[%]
5
10
10
5
50
1
Table C.4: Influence of d1/a ratio to initial uncertainty
It is advisable for the measurement to be repeated at different placements of test
probes.
The test probes shall also be placed in the opposite direction from tested electrode (180°
or at least 90°). The final result is an average of two or more partial results.
According to IEC 60364-6 the distances S’-S (measurement 2) and S’’-S (measurement
3) shall be 6 m.
Equilateral placement
Figure C.4: Equilateral placement
Measurement 1
Distance from tested earthing electrode to current probe H and voltage probe S should be at
least:
ad = 5
2
Measurement 2
Distance from earthing electrode to voltage probe S (S’):
d2, contrary side regarding to H
143


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Metrel MI 3288 - EI Tester at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Metrel MI 3288 - EI Tester in the language / languages: English as an attachment in your email.

The manual is 5.13 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info