Manual Metrel MD 9070 (page 6 of 116) (English, German, French, Italian)

776305

Zoom out

Zoom in

1/116

MD 9070 Insulation/Continuity Digital Multimeter Safety

WARNING

To reduce the risk of fire or electric shock, do not expose this product to rain or moisture.

To avoid electrical shock hazard, observe the proper safety precautions when working

with voltages above 60 VDC or 30 VAC rms. These voltage levels pose a potential

shock hazard to the user. Do not touch test lead tips or the circuit being tested while

power is applied to the circuit being measured. Keep your fingers behind the finger

guards of the test leads during measurement. Inspect test leads, connectors, and

probes for damaged insulation or exposed metal before using the instrument. If any

defects are found, replace them immediately. Never attempt a voltage measurement

with the test lead inserted into the /mA or input jack that is available. Only

replace the blown fuse with the proper rating as specified in this manual. Only use the

Test Probe Assemblies provided with the equipment or UL Listed Probe Assemblies

with same rating or better. IEC 61010-031 requires exposed conductive test probe tips

to be ≤ 4 mm for CAT III & CAT IV ratings. It is commonly achieved by permanently

over-molded plastic shrouds, or by detachable Cap shrouds for interchangeable

between CAT II ratings. Refer to the category markings on your probe assemblies as

well as on the add-on accessories (like Caps or Clips), if any, for applicable rating

changes.

CAUTION

Disconnect the test leads from the test points before changing functions. Always set the

instrument to the highest range and work downward for an unknown value when using

manual ranging mode.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Metrel MD 9070 in the language / languages: English, German, French, Italian as an attachment in your email.

The manual is 45.39 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Metrel MD 9070 Manual

Product: