Manual Metabo HWW 4000-20G (page 11 of 49) (English, German, Dutch, Danish, French, Spanish)

658081

Zoom out

Zoom in

1/49

ENGLISH

1. Pump Overview.........................10

2. Please Read First!.....................11

3. Range of Application and

Pumping Media .........................11

4. Safety .........................................11

4.1 Specified Conditions of Use........11

4.2 General Safety Instructions ........11

5. Prior to Operation .....................12

5.1 Installation...................................12

5.2 Connecting the Suction Line.......12

5.3 Discharge Port............................12

5.4 Connection to a Pipe System .....12

5.5 Connection to AC Power ............12

5.6 Filling the pump and priming.......12

6. Operation...................................12

6.1 Commissioning ...........................13

7. Care and Maintenance..............13

7.1 Danger of Ffreezing....................13

7.2 Pump Dismounting and

Storing ........................................13

8. Trouble Shooting......................13

8.1 Locating the Fault .......................13

8.2 Adjusting the Pressure Switch ....13

8.3 Increasing the Precharge

Pressure .....................................14

9. Repairs.......................................14

10. Environmental Protection........14

11. Available Accessories.........14/49

12. Technical Specifications..........15

These operating instructions have been

written to make it easier for you, the

operator, to learn how to operate this

pump and to do so safely. These instruc-

tions should be used as follows:

 Read these instructions before use.

When reading these instructions,

pay special attention to all safety

instructions.

 These operating instructions are

intended for people with basic tech-

nical knowledge regarding the oper-

ation of a pump like this or similar

pumps. Inexperienced persons are

advised to seek competent advise

from an experienced person before

operating this pump.

 Keep all documents supplied with

the pump for future reference.

Retain proof of purchase for possi-

ble warranty claims.

 This pump must not be sold or lent

to someone else without being

accompanied by these operating

instructions and all other machine

documents supplied with the pump.

 The manufacturer assumes no liabil-

ity for any damage resulting from the

non-observance of any operating or

safety instructions given in this man-

ual.

The information in these instructions is

denoted as under:

Danger!

Risk of personal injury or

damage to the environ-

ment.

Risk of electric shock!

Risk of personal injury

by electric shock.

Caution!

Risk of material damage

Note:

Additional information.

 Numbers in illustrations (1, 2, 3, ...)

 indicate component parts;

 are consecutively numbered;

 refer to the corresponding num-

bers in brackets (1), (2), (3) ... in

the neighbouring text.

 Instructions to be carried out in

sequence are numbered.

 Instructions which can be carried

out in any sequence are preceded

by a bullet (•).

 Listing are preceded by a dash (–).

This pump is intended for pumping clear

water in domestic applications, such as

 irrigation,

 well, rain and service water pump-

ing,



draining of pools, garden ponds and

water tanks.

The max. permissible temperature of the

pumped medium is 35 °C.

4.1 Specified Conditions of

Use

This pump must not be used to supply

drinking water or for pumping foodstuff.

Explosive, flammable, aggressive fluids

or substances detrimental to health as

well as salt water must not be pumped.

This pump is not suitable for commercial

or industrial use.

Modification of the pump or use of parts

not approved by the manufacturer is not

permitted.

Any use other than the use specified

above may cause unforeseeable dan-

ger!

4.2 General Safety Instruc-

tions

Children, juveniles and persons not fam-

ilar with the instructions are not permit-

ted to operate the pump.

When used in swimming pools and gar-

den ponds and within their range of pro-

tection, the regulations of DIN VDE 0100

-702, -738 or applicable local regulation

must be observed.

When used as domestic water supply

any applicable local regulations pertain-

ing to water supply and waste water dis-

posal, plus DIN 1988 (where applicable)

have to be observed.

The following residual risks do principally

exist when operating pumps and pres-

sure vessels and can not be fully elimi-

nated – even by employing safety

devices.

Hazard generated by ambient

conditions!

x Do not expose to rain. Do not oper-

ate in damp or wet environment.

x Do not use the pump in hazardous

locations or near inflammable liquids

and gases!

Danger! Risk of electric shock!

x Do not direct water jet directly

against the pump or other electrical

parts! Risk of fatal electric shock!

x Do not touch the plug with wet

hands! To unplug always pull on the

plug, not the power cable.

x The earthed outlet or the plug con-

nection to an extension cable must

be located in an area safe against

flooding.

x Use only extension cables of suffi-

cient lead cross section (see

"Technical Specifications"). Com-

pletely unroll cable reels.

x Do not buckle, squeeze, drag or

drive over power cable and exten-

sion cables; protect from sharp

edges.

x Place extension cable so that it can

not get into the fluid to be pumped.

x Unplug:

 prior to all servicing;

 when persons are in the swim-

ming pool or garden pond.

Danger by pump failures!

x If you notice transport damage while

unpacking, notify your supplier

immediately. Do not operate the

pump!

Table of Contents

2. Please Read First!

3. Range of Application and

Pumping Media

4. Safety

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Metabo HWW 4000-20G in the language / languages: English, German, Dutch, Danish, French, Spanish as an attachment in your email.

The manual is 0,89 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Metabo HWW 4000-20G Manual

Product: