797737

Mesko MS 4080 Manual

4
Zoom out
Zoom in
Previous page
1/80
Next page
4
25. Do not start the empty mixing cup, without product inside.
24. The device is not suitable for whipping egg whites, kneading dough or grinding meat.
26. MAXIMUM PERIOD OF CONTINUOUS BLENDER OPERATION IS 2 MINUTES. After
2 minutes of continuous operation stop the device and wait couple of minutes before
restarting.
DEVICE DESCRIPTION: BLENDER Ms4080
1 – Measurement cup 2 – Lid 3 – Glass jug 1,5 liters
16. Do not insert fingers or any other objects into blender's cup when the blender is on.
21. Do not wash any blender parts in dishwashers.
23. Do not put any products other than food and liquids in the blender cup. Do not put hot
products in the cup.
20. Handle the blades with extreme care while disassembling accessories. The blades can
cause cuts.
22. Change the accessories only when the device is switched off. Disconnect the device
from the power.
Don't use aggressive detergents to clean the housing, as it may remove the informational
graphic symbols such as: scale, signs, safety marks, etc.
19. For safety reasons use only original accessories and spare parts intended for particular
blender type, available at authorised service centre.
17. In order to avoid injuries handle the blades carefully.
18. Watch out for long hair, scarves, neckties hanging above the cup and operating
components of device.
5. When the blender is in the state of idle operation, e.g. there is no foods in the glass jug, you mustn’t work the appliance for more than
10 seconds to avoid gasket damage.
Before first use:
2. Place the jug on the motor housing (7) and remember to close the lid (2) before each use.
1.Place assembled blender on stable, flat surface.
2. Make sure the speed adjustment knob (8) is set to the OFF position.
1. Place the jug upside down on a flat, stable surface. Place the plastic round ring (10) below jug’s threat, then place the gasket (4) on
glass threat and next place the blade (5), then place the plastic nut (6) and turning it in the right side until all parts will be tightly screwed.
place (Picture 3).
7 – Motor’s housing 8 – Speed adjustment knob 9 – Blue light knob’s illumination
6. Overfilling can block the operation, please turn off the unit and pull out the plug, take out some of food, then operating.
ASSEMBLY / DISASSEMBLY
DEVICE OPERATION
4 – Gasket 5 – Blade 6 – Plastic nut
b) crush ice, if you want to crush ice, the quantity of ice in glass jug should be about 10 pieces, and size of the ice cube should not be
more than 30*23*23mm.
3. Disassemble in reverse order in relation to assembly.
3. To disassemble, proceed in the reverse order to assembly.
4. Do not allow continuous operation of blender for longer than 2 minutes. Later let the device cool down by 1 minute at least.
USEAGE:
3. The blender is used to:
2. Place the jug on the motor’s base (7) and remember to cover the lid (2) before each using.
1. Remove all stickers from the housing, jug and lid of the blender.
1. Place the jug upside down on a flat, stable surface. Place the plastic round ring (10) below the glass thread of the jug, then place the
gasket (4) over the glass thread, then position the blade (5). Then put the plastic nut (6) on all parts placed before and turn it clockwise
until all parts are screwed tightly (photo 3).
2. Wash the jug and the lid in warm water with washing-up liquid, rinse thoroughly, dry the inside and outside of the jug.
10 – Plastic round ring
a) blend fruits and vegetables, so before blending, you must cut the food into slices with 10-15mm.
ASSEMBLY / DISASSEMBLY
… 4 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Mesko MS 4080 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Mesko MS 4080 in the language / languages: English, German, Dutch, Danish, French, Italian, Polish, Portuguese, Swedish, Spanish, Finnish as an attachment in your email.

The manual is 4.55 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info