669488
2
Zoom out
Zoom in
Previous page
1/2
Next page
Schneider Electric Industries SAS
35 rue Joseph Monier
CS 30323
F-92506 Rueil Malmaison Cedex (France)
tel : +33 (0)1 41 29 70 00
http://www.schneider-electric.com
Réalisation : SEDOC 04 76 18 04 11 4291355BH-02/2009
This product must be installed, connected and used in compliance with prevailing standards and/or installation regulations.
As standards, speci cations and designs develop from time to time, always ask for con rmation of the information given in this publication.
Installierung, Anschluss und Benutzung dieses Erzeugnisses müssen unter Einhaltung der gültigen Normen und Montagevorschriften
erfolgen.
Aufgrund der ständigen Weiterentwicklung der Normen und Materialien sind die technischen Daten und Angaben bezüglich der Abmessungen erst nach
einer Bestätigung durch unsere technischen Abteilungen gültig.
Dit product moet worden geïnstalleerd, aangesloten en gebruikt volgens de geldende normen en/of installatievoorschriften.
Wegens het evolueren van normen en materialen zijn de aangegeven technische speci caties en afmetingen pas bindend na onze schriftelijke
bevestiging.
2 200
lux
2 200
7
Technical features / Technische Daten / Technische kenmerken
Power supply: 220...240 V a
Frequency: 45/60 Hz
Breaking capacity: 10 A / 250 V a cos φ = 1
For the uo / halogen lamps: relay
Max. capacity of connection terminals = 6 mm
2
Separate photoelectric cell: ref. 15281
b
b
b
b
b
5
Adjust / Einstellung / Instelling
Luminosity threshold from 2 to 200 lux:
turn potentiometer
1
from "2" to "200" until the desired adjustment is reached.
the LED instantly lights up when the displayed threshold is reached.
The switch is time delayed at interlocking and disconnection (approx. 40 sec).
NB:
To check that your device is operating correctly replace the probe by a 47 kΩ resistor
(approximately 150 lux) provided in the case.
Adjust the potentiometer
1
so as to make the red LED light up. Wait 40 seconds for the relay
to trip.
Helligkeitsschwelle von 2 bis 200 Lux:
Das Potentiometer
1
von "2" nach "200" drehen bis zur gewünschten Einstellung.
Die Anzeigelampe leuchtet sofort auf, wenn die eingestellte Schwelle erreicht ist.
Der Schalter schaltet verzögert ein und aus (ca. 40 sec).
Hinweis:
Zur Sicherstellung der Funktion des Gerätes ist anstelle des Sensors ein Widerstand von 47 kΩ
(etwa 150 lux) anzubringen (im Lieferumfang enthalten).
Mit dem Potentiometer
1
die rote LED auf leuchtend einstellen. Umschalten des Relais
innerhalb von 40 Sekunden abwarten.
Helderheidsdrempel instelbaar van 2 tot 200 lux:
de potentiometer
1
van "2" naar "200" verdraaien tot de gewenste instelling bereikt is.
het rode kontrolelampje gaat onmiddellijk branden zodra de aangeduide drempel
bereikt wordt. De schakelaar werkt met een vertraging van ongeveer 40 s bij het in- en
uitschakelen.
Opmerking:
Om u te vergewissen van de correcte werking van het apparaat dient u de sensor te vervangen
door een weerstand van 47 kΩ (ongeveer 150 lux), die zich in de doos bevindt.
Verdraai de potentiometer
1
zodat de rode LED gaat branden. Na een wachttijd van 40
seconden moet het relais omschakelen.
b
b
b
b
b
b
6
Technical features / Technische Daten / Technische kenmerken
en
de
nl
IC200 Lighting Beleuchtung Verlichting
2300 W 230 V incandescent lamps Glühlampen 230 V Gloeilampen 230 V
2300 W 230 V halogen lamps Halogenlampen 230 V Halogeenlampen 230 V
46x36 W, 23x58 W,
14x100 W
Non-compensated / serial-compensated
uorescent tubes
Leuchtstof ampen nicht kompensiert /
reihenkompensiert
Niet gecompenseerde uorescentielampen /
gecompenseerde uorescentielampen in serie
10x36 W (4.7μF),
6x58 (7μF), 2x100 W
(18μF)
Parallel-compensated uorescent tubes with
conventional ballast
Leuchtstof ampen parallelkompensiert mit
konventionellen Vorschaltgerät
Gecompenseerde uorescentielampen in
parallel met conventionele ballast
11x(2x58 W) -
6x(2x100 W)
Parallel-compensated uorescent tubes with
conventional ballast
Leuchtstof ampen in Duo - Schaltung Fluorescentielampen (dubbel)
9x36 W, 7x58 W Fluorescent tubes with electronic ballast Leuchtstof ampen mit elektronischem
Vorschaltgerät
Fluorescentielampen met elektronische ballast
5x(2x36 W),
4x(2x58 W)
Fluorescent tubes with dual connected
electronic ballast
Leuchtstof ampen in Duo - Schaltung mit
elektronischem Vorschaltgerät
Fluorescentielampen met elektronische ballast
(dubbel)
6x7 W, 8x11 W,
6x15 W, 6x20 W
Fluocompact lamp with electronic ballast Kompaktleuchtstof ampen mit elektronischem
Vorschaltgerät
Compactlampen met elektronische ballast
2300 W Fluocompact lamp with conventional ballast Kompaktleuchtstof ampen mit konventionellen
Vorschaltgerät
Compactlampen met conventionele ballast
1x250 W (30μF) Parallel-compensated mercury vapour lamp Quecksilberdamp ampen parallelkompensiert Gecompenseerde HQL uorescentielamp in
parallel
1x250 W (37μF) Parallel-compensated sodium-vapour lamp Natriumdamp ampen parallelkompensiert Gecompenseerde natriumlamp in parallel
Betriebsspannung: 220...240V
a
Netzfrequenz: 45/60 Hz
Schalteistung: 10 A / 250 V a cos φ = 1
Für die Lampen Fluor-Halogen: Relais
Max. Leistung der Anschlussklemmen = 6 mm
2
Separate photoelektrische Zelle: ref. 15281
b
b
b
b
b
Voedingsspanning: 220...240 V
a
Frekwentie: 45/60 Hz
Onderbrekingsvermogen: 10 A / 250 V a cos φ = 1
Voor uolampen / halogeenlampen: een
magneetschakelaar gebruiken.
Maximumvermogen van de aansluitklemmen = 6 mm
2
Afzonderlijke fotoelektrische cel: ref. 15281
b
b
b
b
b
2- Notice space
2- Platz-
Bedienungsanleitung
2- Opbergruimte
en
de
nl
en
de
nl
en
de
nl
2


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Merlin Gerin IC200 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Merlin Gerin IC200 in the language / languages: Dutch as an attachment in your email.

The manual is 0,58 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info