494939
21
Zoom out
Zoom in
Previous page
1/40
Next page
Customising the analogue controller
17
To configure a source
Switch off the analogue controller, using the power switch on
the back panel.
Switch on the power again while holding down the Display
key on the front panel.
The display will show:
Config
Press Source until the left-hand pair of characters identifies
the source you want to configure.
For example, to configure the CD
source the display initially shows:
CD CD
Press Copy (front panel), or
>>
>>
> and
<<
<<
< (remote), to step
between options.
The right-hand pair of characters shows the current value of the
option.
The options are summarised in the table shown on the next
page.
To change an option
Press A or V to step between the alternative values for the
option.
When you have finished programming sources:
Switch off the analogue controller, using the power switch on
the back panel.
Switch on again to restore normal operation.
21


Need help? Post your question in this forum.

Forumrules
1

Forum

meridian-502

Reset search

  • My Meridian 502 preamp has no power. I have replaced fuse and still no power. Fuse has not blown. Submitted on 16-2-2022 at 18:24

    Reply Report abuse


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Meridian 502 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Meridian 502 in the language / languages: English as an attachment in your email.

The manual is 0,33 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info