Manual Mercedes ML 350 - 2008 (page 304 of 561) (English)

622505

304

Zoom out

Zoom in

1/561

303

Controls in detail

Useful features

Programming the integrated remote

control

Step 1:

왘 Switch on the ignition (컄 page 40).

Step 2:

왘 If you have previously programmed a

signal transmitter button and wish to

retain its programming, proceed to

step 3.

If you are programming the integrated

remote control for the first time, press

and hold the two outer signal transmit-

ter buttons 2 and 4 and release

them only when indicator lamp 1

begins to flash after approximately

20 seconds (do not hold the button for

longer than 30 seconds). This proce-

dure erases any previous settings for

all three channels and initializes the

memory.

If you later wish to program a second

and/or third hand-held transmitter to

the remaining two signal transmitter

buttons, do not repeat this step and be-

gin directly with step 3.

Step 3:

왘 Hold end of the hand-held remote

control 5 of the device you wish to

train approximately 2 to 5 in

(5 to 12 cm) away from the signal

transmitter button (2, 3 or 4) to be

programmed, while keeping the indica-

tor lamp 1 in view.

Step 4:

왘 Using both hands, simultaneously

press hand-held remote control

button 6 and the desired signal trans-

mitter button (2, 3 or 4). Do not

release the buttons until step 5 is com-

pleted.

Indicator lamp 1 will flash, first slowly

and then rapidly.

When programming a garage door opener,

park the vehicle outside the garage.

Do not run the engine while programming

the integrated remote control. Inhalation of

exhaust gas is hazardous to your health.

All exhaust gas contains carbon monoxide

(CO), and inhaling it can cause unconscious-

ness and possible death.

Indicator lamp 1 flashes immediately the

first time the signal transmitter button is

programmed. If this button has already been

programmed, the indicator lamp will only start

flashing after 20 seconds.

컄컄

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Mercedes ML 350 - 2008 in the language / languages: English as an attachment in your email.

The manual is 14,73 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Mercedes ML 350 - 2008 Manual

Product: