Manual Mercedes E-Class Sedan 2015 (page 329 of 426) (English)

624692

329

Zoom out

Zoom in

1/426

system. Several attempts might be neces-

sary. You should test every position for at

least 25 seconds before trying another

position.

Problems when programming

If you are experiencing problems programing

the integrated garage door opener on the

rear-view mirror, take note of the following

instructions:

Check the transmitter frequency used by

garage door drive remote control A and

whether it is supported. The transmitter

frequency can usually be found on the back

of the garage door drive remote control.

The integrated garage door opener is com-

patible with devices that have units which

operate in the frequency range of 280 to

433 MHz.

Replace the batteries in garage door

remote control A. This increases the like-

lihood that garage door remote control A

will transmit a strong and precise signal to

the integrated garage door opener.

When programming, hold remote control

A at varying distances and angles from the

button which you are programming. Try var-

ious angles at a distance between 2and

12 inches (5to 30 cm) or at the same angle

but at varying distances.

If another remote control is available for the

same garage door drive, repeat the same

programming steps with this remote con-

trol. Before performing these steps, make

sure that new batteries have been installed

in garage door drive remote control A.

Note that some remote controls only trans-

mit for a limited amount of time (the indi-

cator lamp on the remote control goes out).

Press button B on remote control A again

before transmission ends.

Align the antenna cable of the garage door

opener unit. This can improve signal recep-

tion/transmission.

Opening/closing the garage door

After it has been programmed, the integrated

garage door opener performs the function of

the garage door system remote control.

Please also read the operating instructions

for the garage door system.

Turn the SmartKey to position 2 in the igni-

tion lock (Y page 157).

Press button ;, = or ? which you have

programmed to operate the garage door.

Garage door system with a fixed code: indi-

cator lamp : lights up green.

Garage door system with a rolling code:

indicator lamp : flashes green.

The transmitter will transmit a signal as long

as the button is pressed. The transmission is

halted after a maximum of ten seconds and

indicator lamp : lights up yellow. Press but-

ton ;, = or ? again if necessary.

Clearing the memory

Make sure that you clear the memory of the

integrated garage door opener before selling

the vehicle.

Turn the SmartKey to position 2 in the igni-

tion lock (Y page 157).

Press and hold buttons ; and ?.

The indicator lamp initially lights up yellow

and then green.

Release buttons ; and ?.

The memory of the integrated garage door

opener in the rear-view mirror is cleared.

Floormats

WARNING

Objects in the driver's footwell can restrict the

pedal travel or obstruct a depressed pedal.

The operating and road safety of the vehicle is

jeopardized. There is a risk of an accident.

Make sure that all objects in the vehicle are

stowed correctly, and that they cannot enter

the driver's footwell. Install the floormats

Features

327

Stowage and features

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Mercedes E-Class Sedan 2015 in the language / languages: English as an attachment in your email.

The manual is 8,67 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Mercedes E-Class Sedan 2015 Manual

Product: