820628

Memphis Grills VG084 Manual

35
Zoom out
Zoom in
Previous page
1/39
Next page
35
Problem Cause Solution
Error Message "ER- 1
Grill Overheat"
The appliance has overheated,
possibly due to a grease fire, or
excess fuel.
Turn the grill off and allow it to cool. If necessary, follow the procedure in the
General Warning section. Clean grill interior and clear off excess fuel before
restarting.
Error Message "ER- 2
Failed to Light"
Check the hopper for sufficient fuel.
Check the burn pot for ash build-up or other obstructions.
Check igniter to see if it is heating up (igniter may need replacing).
In extreme cold, grill may require additional priming to achieve ignition.
Make sure hood is closed.
Grill will not stay lit. Check the hopper for sufficient fuel.
Check the burn pot for ash build-up or other obstructions.
Blower not supplying the air needed to maintain a flame.
Check igniter to see if it is heating up, used to recover if temperature falls below the
set temperature.
Make sure hood is closed.
Error Message "ER- 3
Unplugged Before
Cooldown"
The appliance has power
failure during operation.
Ensure that your grill is securely plugged in.
Check for power-failures within your home.
Error Message "ER– 4
RTD Shorted"
RTD or Meat Probes
damaged
Check resistance of RTD and meat probes
Replace RTD harness, meat probe, or probe jack.
Contact Memphis Grills Technical Support.
Error Message "ER- 5
RTD Open"
There is a malfunction with either
the RTD or Meat Probes or a wire
has disconnected.
Check continuity of RTD and meat probes
Replace RTD harness, meat probe, or probe jack.
Contact Memphis Grills Technical Support.
Error Message "ER– 6
CPU Overtemp"
Electrical Compartment is
becoming too hot for the controller.
Verify the Auxiliary fan is spinning once the grill is put into start mode.
Replace Auxiliary fan.
Contact Memphis Grills Technical Support.
Error Message "ER– 8
Invalid Mode, Check
Set Temp"
ITC doesn’t reflect to selected grill
mode
Change the set temperature
Press and hold push button for 10 seconds to reset controller.
Error Message "ER-9
Igniter Fault"
Igniter Fuse blown, igniter
damaged, or break in igniter
harness wires.
Verify continuity of Igniter harness
Check 4A SLO-BLO fuse for continuity
Contact Memphis Grills Technical Support
Error Message "ER-10
SD Card Fault"
SD card not inserted, damaged, or
missing
Disconnect SD card from control board and re-insert. Restart grill by unplugging and
plugging back in
Contact Memphis Grills Technical Support
Grill Will Not Turn On Grill is not properly plugged in. Ensure that your grill is plugged into a working GFCI outlet.
Fuse must be manually replaced. See guide at the end of this section
Contact Memphis Grills Technical Support
Grill Produces
Excess or
Discolored Smoke
Wood pellets have absorbed excess
moisture.
Clear the hopper and burn pot of moist pellets, replacing them with dry pellets.
Burn pot is overloaded with ash
build-up.
Check the burn pot for ash build-up or other obstructions.
In the event that your Memphis grill encounters any kind of issue or problem in operation, please consult this chart. If
the solutions offered here are insufficient to resolve the matter, please contact your dealer, or Memphis Wood Fire Grills
directly at the number found at the end of this manual.
Troubleshooting and Error Messages
… 35 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Memphis Grills VG084 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Memphis Grills VG084 in the language / languages: English as an attachment in your email.

The manual is 8.82 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info