508297
19
Zoom out
Zoom in
Previous page
1/30
Next page
19
PRIOR TO FIRST USE
Place the base unit on a flat surface, e.g. a
kitchen counter, and make sure it is standing
firmly.Beforeusingthemultimixerforthefirst
time, or after prolonged storage without use,
wash and dry any parts that will come into
contact with food.
USING THE MULTIMIXER
Multimixer parts
Thebaseunit(3)containsamotor.Youcanfit
different accessories onto the drive shaft of the
base unit, depending on the type of food you
wanttoprepare.Usethebladeunit(7)tochop,
grate, blend, stir, grind and whip foods either in
thejug(6)orinthepreparationbeakers(4).The
preparation beakers can also be used to cook
or reheat food in a microwave oven or to store
leftoversinthefridge.Twostoragelids(5)are
supplied for this reason. However, the storage
lids are not suitable for use in a microwave oven.
Use of preparation beakers
• Placefoodinoneofthepreparation
beakers.
• Screwthebladeunitontothebeaker.
• Placethebeakeronthedriveshaftonthe
base unit, so the pins on the beaker are lined
up with the depressions in the base unit.
• Holdthebaseunitdownwithonehandand
press down on the beaker with the other
hand.
Themotorrunsaslongasyoupressthe
beaker down. You can also get the motor to run
continuously by pressing the beaker down and
turning it slightly in a clockwise direction until
the pins lock into place under the black edge
of the base unit. Stop the motor by turning the
beaker slightly in an anti-clockwise direction
to release the pins. See also “Preparation
Techniques”below.
Using the blender jug
• Screwthebladeunitontotheblenderjug.
• Placethefoodintheblenderjug.
• Placethelid(1)ontheblenderjug,andturn
it in a clockwise direction until it clicks into
place.
• Placethecap(2)intheholeintheblender
juglid,sothepinsonthecapfitintothe
holesinthelid.Turnthecapslightlyina
clockwise direction until it clicks into place.
• Placetheblenderjugonthedriveshafton
the motor unit, so the pins on the beaker are
lined up with the depressions in the base
unit.
• Startthemultimixerasdescribedabove.
Ifyouwanttoaddmoreingredientsasyougo
along, you can remove the cap from the lid by
turning the cap anti-clockwise and lifting it up.
Stop the multimixer before removing the cap to
avoidsplashes.Ifyouneedtoscrapeinsideor
empty the blender beaker, wait until the blade
has stopped completely before removing the lid!
Never use your fingers to scrape with.
Important!Neverleavethemultimixerrunning
for more than 1 minute at a time, as the motor
canoverheat.Ifthepreparationprocess
requires longer than this, take a short break
before starting the multimixer again. You should
also stop the multimixer at regular intervals to
check whether the items have been processed
sufficiently.Ifthemotoroverheatsandstops
running, unplug the multimixer and allow it cool
down for several hours before using it again.
Important!Ifthebladegetsstuckwhilethe
motor is running continuously, unplug the
multimixer immediately to prevent damage to
the motor. Remove the beaker fitted with the
blade unit from the base unit, and shake the
ingredientsinthebeakerthoroughly.Iftheblade
is still stuck, unscrew the blade unit from the
beaker and carefully turn the blade round using
yourfingers.Becareful-thebladeisextremely
sharp! Once you are sure the blade can go
round, fit the blade unit into the beaker, place
the beaker onto the base unit and try again.
Important!Ifthemultimixeristobeusedto
prepare different types of food (e.g. raw meat
followed by vegetables, or egg followed by fruit),
you must wash the parts that come into contact
with food between each type of food.
Preparation techniques
Pulsetechnique–Ifyouwantthefoodtobe
chopped or blended coarsely, then instead of
holding the beaker down, press it down briefly
and intermittently a number of times with
shortbreaksbetween.Takecarenottolock
the beaker into position, or the motor will run
continuously.
Shakingtechnique–Ifthebladeisnot
distributing the food properly in the beaker, you
can lock the beaker into position so the motor
is running continuously, lift the entire multimixer
up from the counter and shake it back and
forth a few times so the food shifts position in
thebeaker.Thenputthemultimixerbackon
thecounterandletitrunalittlelonger.Bevery
careful when you use the shaking technique!
Hold both beaker and base unit firmly to prevent
them separating from each other while you are
shaking them.
19


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Melissa 646-104 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Melissa 646-104 in the language / languages: English, German, Danish, Polish, Swedish, Norwegian, Finnish as an attachment in your email.

The manual is 0,84 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info