509372
21
Zoom out
Zoom in
Previous page
1/36
Next page
STEP 2 – BACK OF THE NECK.
Change to the next longest comb attachment
9mm or 12mm and cut the back of the head (see
Fig. 2).
STEP 3 – SIDE OF THE HEAD.
Change to one of the shorter combs 3mm or 6
mm, trim sideburns, i.e. the hair directly in front
of the ears. Then change to one of the longer
combs, 9mm or 12mm, and continue to cut to
the top of the head ( see Fig. 3).
STEP 4 – TOP OF THE HEAD.
1. Using comb attachment 9mm or 12mm, cut
the top of head from back to front against
the direction in which the hair normally
grows (see fig. 4). In some cases, this may
require the reverse, or cutting from front to
back.
2. Comb attachment 3mm or 6mm are used to
achieve a close crew cut or short cut.
3. For longer hair on top, use the comb
provided and lift hair on the top of the head.
Cut over the comb, with the hair lifted or
hold the hair between the fingers to lift it and
cut it to desired lenght ( see fig. 5 and 6).
Always work from the back of the head. You
can cut the hair shorter gradually by
reducing the space between the
comb/fingers, and the head. Comb out
trimmed hair and check for uneven strands.
STEP 5 – THE FINISHING TOUCH.
1. Finally use the taper lever without an
attachment comb for close trimming around
the base of the neck, the sides of the neck
and the ears.
2. To produce a clean straight line at the
sideburns, reverse the hair clipper by turning
the reverse side uppermost (see fig. 7).
3. Press the clipper at right angels to the head,
tips of the blades lightly touching the skin
and work downwards. This way you will
obtain, as a clean cut as would be given by
a razor.
SHORT TAPPERED STYLES – “FLAT TOPS”
AND SHORT CUTS
1. Starting with the longest attachment comb
(12mm), cut from the back of the neck to the
crown. Hold the attachment comb flat
against the head and slowly move the
clipper through the hair, as shown (see fig.
8).
2. Use the same procedure from the lower side
to the upper side of the head, as illustra ted.
Then cut the hair against the direction in
which it grows from the front to the crown
and then level the cut with the sides.
3. To give a “flat top” look, the hair on the top
of the head must be cut over the top of the
head must be cut over the top of a flat comb
rather than by using the attachment comb.
4. Use closer cutting attachment combs to
taper the hair down to the neckline as
desired. Comb hair and check for uneven
areas and outlining sideboards and neckline
as described previously.
ENVIRONMENTAL TIP
An electronic appliance should, when it is no
longer capable of functioning be disposed with
least possible environmental damage. The
appliance should be disposed according to the
local regulations in your municipality, in most
cases you can discharge the appliance at your
local recycling center.
THE WARRENTY DOES NOT COVER
- If the above points have not been observed.
- If the appliance has not been properly
maintained, if force has been used against it
or if it has been damaged in any other way.
- Errors or faults owing to defects in the
distribution system.
- If the appliance has been repaired or
modified or changed in any way or by any
person not properly authorized.
Owing to our constant development of our
products on both functionality and design we
reserve the right to change the product without
preceding notice.
IMPORTER:
Elof Hansson A/S
Elof Hansson AB
We take reservation for printing errors.
21
HC28 IM 08/05/02 11:42 Side 21
21


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Melissa 638-125 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Melissa 638-125 in the language / languages: English, German, Danish, Polish, Swedish, Norwegian, Finnish as an attachment in your email.

The manual is 0,42 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info