507952
28
Zoom out
Zoom in
Previous page
1/44
Next page
28
29
Positioning the appliance
• Alwaysplacetheapplianceonadry,level,rmand
heat-resistantsurfacewellawayfromanyedges.
• Thebackoftheappliancemustbesupportedbya
rear wall.
Connection
1. Theappliancemustbeconnectedtoa230-voltAC
current, 50 Hz.
2. Always use new hoses when installing the
appliance. Old hoses should not be reused for new
installations.
3.
º
The water intake on the appliance ends in a ¾”
female plug – check that the correct hose is
used.
º
Do not overtighten the connection, as this can
damage the thread.
º
There should be a stopcock connected to the
hose, so it is easy to disconnect the water supply
to the appliance.
º
Regulations stipulate that the water tap
connectionshouldbewithanon-returnvalve.
However, we recommend that the appliance has
apermanentconnectiontothewatersupply.You
must ensure that the correct spacers or adapters
are used to connect the appliance in a safe and
responsible way.
º
The appliance can be connected to both hot and
cold water supply.
• Ifthehotwatersupplytemperaturecannot
be maintained under 60 ºC, the appliance
must be connected to the cold water supply,
as it may be damaged by water that is too
hot.
• Whenconnectedtohotwater,washtimes
are reduced by approximately 15 minutes.
There will also be a slight reduction in wash
efciency.
º
The appliance is equipped with a water level
gauge, which ensures that the appliance stops
automatically if there is a drop in water pressure.
4.
until the hose is secure.
º
The drainage hose is fed upwards like an
upturnedUovertheaccompanyingplastic
thedrain.Thispreventsdrainagewaterowing
back into the appliance. For increased
protection,areuxvalve(notincluded)canbe
used.
º
The drainage hose should be fed down into
a drainage pipe, which must be no higher than
max. 75 cm above the base of the appliance.
The drainage pipe diameter should be at least
4 cm in order to ensure that air can escape
around the drainage hose. Extra drainage hose (if
any):max.length4m.
5. Turn water on.
NOTE!ASSOONASTHEWATERSUPPLYISTURNED
ON,THEREISPRESSURISEDWATERINTHEHOSE
ANDAPPLIANCE,EVENIFTHEWATERSUPPLYIS
SUBSEQUENTLYTURNEDOFFAGAIN!
Fitting the lter, rack and cutlery basket
• Fittheltersinthebaseoftheappliance.
º
Fitthemainlter(9)rst.Theninsertthene
andcoarselterelement(8).Thenturnthelter
clockwise.
º
Checkthattheltersarecorrectlyttedandthat
the dishwasher arm (7) rotates freely and can
turn a complete circle.
• Therack(1)isequippedwithwheels,sothatit
slides easily in and out.
• Positionthecutlerybasket(2)ontherack.The
cutlery basket can be removed from the rack if it
is not required, e.g. when washing serving dishes,
bowlsandotherlargeobjects.
Filling salt
Water hardness varies from place to place and from
waterworks to waterworks. Hard water can leave
white deposits on dishes and requires more detergent.
This appliance is therefore equipped with a softener,
which softens the water in the appliance with the aid
of salt, which helps to ensure good washing results.
Softwaterrequireslessdetergent,sothesalthelpsto
reduce detergent consumption and also protect the
environment.
To ll with salt:
• Removethecutlerybasketandscrewoffthesalt
compartment cap (6).
• Fitthefunnel(10)intotheport.Fillwithabout1kg
salt.
• Closecap.
• IMPORTANT!Immediatelyafterllingwithsalt,runa
quick wash program to avoid salt water corrosion of
the parts.
• Rellwithsaltwhenthesaltindicator(c)lightsup.
NOTE!ITISIMPORTANTTOADDSALTBEFORETHE
FIRSTWASHCYCLE!ONLYUSESALTINTENDEDFOR
DISHWASHERS.
Filling dishwasher rinse agent
Thesurface-activesubstancesindishwasherrinse
agent reduce surface tension in the water for quicker,
betterdrying.Usingadishwasherrinseagentalso
means dishes are cleaner and glass remains clear and
shiny.
To ll with dishwasher rinse agent:
• Screwthecapoffthedishwasherrinseagent
compartment (3), turning it to the left (in the
directionofthearrow).Liftcapoff.
• Filldishwasherrinseagentbutbecarefulnotto
overllthecompartment.
• Screwthecapbackon,turningittotheright(inthe
direction of the arrow) to close.
• Rellwhenthedishwasherrinseindicator(d)lights
up.
Screwthehosetothewatersupply(
16
)atthewater
intake (
15
).
14
Attach the drainage hose ( ) to the drainage nozzle
( ) using the hose clip (
17
). Tighten the hose clip
13
U-bend( )beforebeingfeddownwardsinto
12
28


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Melissa 16590008 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Melissa 16590008 in the language / languages: English, German, Danish, Polish, Swedish, Norwegian, Finnish as an attachment in your email.

The manual is 1 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info