5
When you have programmed Speedy 110 Meliconi, note down the code on the label in the battery
compartment cover.
To find the code for your remote control:
1. Hold down the and keys simultaneously until the light indicator at the top starts to flash
indicating that the remote control is searching for the code.
2. Release the keys and, within 12 seconds, press and simultaneously.
3. Release and and pay attention to the flashing of the LED: a long flash corresponds to a + while
a short flash corresponds to a - . Note the sequence of the 9 flashes and note them down on the label
in the battery compartment cover, from left to right.
PROGRAMMING YOUR REMOTE CONTROL
1. Make sure that the TV is ON.
2.Hold down the and keys simultaneously until the light indicator at the top starts to flash indicating
that the remote control is in programming mode.
3. Press key four times then point the remote control at the appliance. Press and release the key
slowly several times. STOP when your TV goes OFF.
4.When your TV is OFF, press the and keys simultaneously. When you release the keys, three
flashes indicate that the search operation has been completed correctly.
Additional check
Check that all 7 keys are operating correctly. If the commands work incorrectly or erratically, you have
probably entered a code for a similar but different remote control.
In this case, repeat the search procedure from point 2 until all keys respond correctly to the commands sent.
IF YOU DO NOT HAVE THE PROGRAMME SELECTION KEYS ON YOUR ORIGINAL REMOTE CONTROL
If your remote control does not have the programme selection keys (e.g. / , +/-, CH+/-..etc) once you
have programmed Speedy 110, you can still select the programmes from 0 to 9, as follows:
• Hold down the and keys simultaneously until the light indicator starts to flash indicating that
the remote control is in programming mode.
• Release the keys and press 9 times within 12 seconds. Three flashes indicate that
the operation has been completed correctly.
• Make sure you can change programmes from 0 to 9 using the and keys. If not, repeat the search
operation, starting from point 2.
Identify and take note of the TV code which you have searched for, following the code noting
procedure (see "PROGRAMMED CODE NOTING" section).
NOTE: DURING THE SEARCH OPERATION, THE LIGHT INDICATOR FLASHES MORE QUICKLY.
THE LIGHT INDICATOR STOPS FLASHING AND YOUR REMOTE CONTROL LEAVES
PROGRAMMING MODE IN THE FOLLOWING CASES:
• if no keys are pressed for 12 seconds
• if you press keys other than those indicated
• if the code search list is completed. In this case, visit www.meliconi.com or contact the call center.
PROGRAMMED CODE NOTING
P
-
+
P
P
-
+
P
P
-
P
-
+
P
P
-
+
P
+
P
