673504
48
Zoom out
Zoom in
Previous page
1/84
Next page
MANUAL DE INSTRUÇÕES · MANUAL DE INSTRUCCIONES
INSTRUCTION MANUAL · GEBRAUCHSANLEITUNG
44
2.3
INSTALLATION AND ASSEMBLY
To ensure that the oven functions correctly, the dimensions shown in the figures in section 10 must be
respected, specifically:
Fresh air inlet in the furniture's skirting board (figure reference A)
Distance from the top of the oven and the bottom of the board placed above it
(figure reference B). Distance between the oven's door and the door of the
adjacent furniture (figure reference C). Fresh air circulation (figure reference D)
The dimensions of the opening are shown on the figures in section 10 (585x560 mm).
Insert the oven into the opening in the furniture by supporting its base and pushing it
right to the back.
Open the door and fix the oven to the furniture using the four bolts supplied (see figure in section 10).
Furniture material must resist temperatures of up to 90°C.
The oven's electrical connection must be made independently of any other connection.
We recommend the following precautions prior to using the oven:
-
remove the protective film covering the oven's door glass (if present):
-
heat the oven to its maximum temperature without food inside for around 45 minutes to eliminate
unpleasant smells and smoke cause by manufacturing residue and the thermal insulation;
-
carefully clean the inside of the oven with soap and water and rinse well with clean water
IMPORTANT: During use, the front of the oven heats up significantly. Care must be taken when touching
these parts.
48
2.1
ELECTRICAL CONNECTION
The oven is fitted with an electrical power supply cable and is designed to operate with alternating current at
the voltage indicated on the plate showing the "oven's technical data", found on a label on the product. The
electric cable's earth connector is yellow and green
2.2
CONNECTING THE CABLE TO THE POWER SUPPLY
The oven must be connected to the power supply by a technically qualified person with knowledge of current
installation standards and regulations.
Before turning the oven on, make sure that the electrical connections and protection devices are suitable for
the product's technical characteristics.
To connect the product to the electricity supply, an all-pole circuit breaker must be installed between the oven
and the power supply, with a minimum gap between the contacts of 3mm. This circuit breaker should be
appropriate for the load and correspond to current safety regulations.
The earth cable, identifiable by its green/yellow colours, must not run through the switch.
The manufacturer shall not be liable for any direct or indirect damage caused by incorrect installation or
connection.
Therefore, all electrical installation and connection work must be carried out by specialist personnel and
work must be done in compliance with current local and general regulations.
INSTALLATION INSTRUCTIONS
EN
2
48


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Meireles MF7606 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Meireles MF7606 in the language / languages: English, German, Portuguese, Spanish as an attachment in your email.

The manual is 8,79 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info