673572
6
Zoom out
Zoom in
Previous page
1/28
Next page
INSTRUCTIONS MANUAL
6
2.2 GAS CONNECTION
The cooker is provided with a label placed on the rear panel near the gas inlet, showing the type of gas and pressure
for which the appliance has been originally adjusted.
Before connecting this appliance check if is prepared for the type of gas and pressure available in your home. If
not, it is necessary to convert the appliance to another gas as indicated in section 2.4.
This appliance is suitable for connection to Natural and Propane Gas. Refer to gas pressure shown on the data
plate and in the table nº 1.
All possible type of gas and pressures are shown on the data plate, and in the table nº 1.
The butane gas bottle are unable to function in places with low temperatures. In this case is recommendable to
substitute the Butane for Propane gas (operation to be done by one qualified installer). Never place a propane gas
bottle inside the building.
You may connect the appliance to a gas bottle fitted with its respective regulator, or to a gas network tap. Since this
is a movable unit, the following types of tubes could be used:
- Flexible rubber or elastomer tube, certified according an applicable standard fixed to an adequate inlet gas
connection and held tight by a clamp on both ends
- Flexible stainless steel tube, certified according an applicable standard, with threaded connections.
- Flexible rubber or elastomer tube, certified according an applicable standard, with threaded connections.
ATTENTION:
- Ensure the tube is not bent or twisted.
- Ensure the tube is not in contact with the rear panel.
- The tube must be replaced before expire date.
- The tube must be checkcable in is whole length.
- The clamps should be adequate for a good tight
- The maximum length of the flexible rubber tube must be 1500 mm.
The connection to the cooker should be done on the same side of the point of feeding, in way that the tube doesn't
cross the backs of appliance. If necessary change the gas inlet or request to the services of technical attendance
the adaptation tube so that the entrance of gas in the appliance is done on the side correct.
After connecting the unit, check eventual leaks with a frothy product. NEVER USE A FLAME.
The connection to the cooker should be done on the same side of the point of feeding, in way that the tube doesn't
cross the backs of appliance. If necessary change the gas inlet or request to the services of technical attendance
the adaptation tube so that the entrance of gas in the appliance is done on the side correct.
After connecting the unit, check eventual leaks with a frothy product. NEVER USE A FLAME.
6


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Meireles E 604 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Meireles E 604 in the language / languages: English as an attachment in your email.

The manual is 0,7 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info