551351
13
Zoom out
Zoom in
Previous page
1/19
Next page
1. Roughen the drawn areas and feet with sandpaper (120 grit) to easily and thoroughly
clean the surface again with Cleaner (WARNING: then no longer touch areas) and let
the clean dry for about 10 minutes.
2. Unless you have a way to run the cable through an existing roof outlet, look for a suita-
ble place (best in the wind shadow behind the antenna) on the roof for the installation
of a roof outlet to avoid the ingress of moisture (eg rain or splash water) in the wellbore.
Make sure that the cables are not curved too much to avoid signal loss and damage
the cable (bending radius max. 5-7 cm).
1. Prepare the glue for mounting.
2. Now take the glue on the underside of the antenna bases in
serpentine lines, so that the glue can harden well to the inside.
3. Now place immediately (within 5 minutes after adhesive application), the antenna on
the marked fields. Press your feet slightly and evenly and fix the antenna so that it
stays in place, eg by an adhesive tape. It must be after pressing for at least 2 mm glue
between antenna and surface. The adhesive is cured max. in 48 hours at +18° C and a
relative humidity of 50%. Should prevail low humidity during the assembly time, spray
after bonding in the vicinity of the antenna always some water in the air.
4. Remove any spilled adhesive immediately with a putty knife or similar and clean the
soiled surfaces with the cleaner and a fleece cloth.
5. For safety, you can attach the antenna bases additionally. Given by drill through the
existing hole in the respective antenna to the roof of your car and fix it with a screw
with locking nut. In order for the freshly bonded feet can not slip, wait with this work
until the adhesive has cured.
6. After the complete assembly and curing of the adhesive, a silicone can be drawn
around the antenna bases.
Connection
Gluing instructions
Install the control unit and the set-top box is not inside the vehicle in the region of an
airbag. Maintain a careful installation of the cable in order to avoid short circuits. Pay
attention also to existing cables.
Connect the antenna as shown in the illustration below:
ENGLISH ENGLISH
06
07
Shipman
12~24 V DC 5 A
Antenna
Receiver
( - )
(+)
or with the optional
power supply
230 V AC / 12 V DC 5A
Television
Receiver
13


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Megasat Shipman at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Megasat Shipman in the language / languages: English, German as an attachment in your email.

The manual is 1,52 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info