551354

Megasat Seaman 45 GPS-Auto Skew Manual

13
Zoom out
Zoom in
Previous page
1/17
Next page
Setting the LNB Skew
Signals in the vertical (red) and horizontal (blue) line have an offset of exactly 90° to each
other. Due to the different position of the satellites, depending on your location, it is pos-
sible that the signals do not meet exactly vertically and horizontally on the LNB. To adjust
this, turn the LNB into the correct position to the transmitted signal. This adjustment to
the LNB is called „skew adjustment“. The following figure shows the optimal setting of the
LNB. More accurate the match, the better of reception.
LNB position
bad reception good reception best reception
Satellite Signal
Startup and operation
1. Turn on the TV and the set-top box. The green LNB LED on the display of the control
box lights up when the satellite receiver is turned on and a supply voltage for the LNB
is available.
2. Turn on the control unit. Then, the indicator of the preset satellites lights red. Shortly
thereafter, the LED starts to flash for about 5 seconds. Only this time you can select
another satellite by press the white key. Each press of the button, the display will con-
tinue to a satellite position. Press it as long until the desired satellite is flashing. Now
the search is started.
3. When a satellite is found, the antenna stop
and carries out a fine-tuning. Then begins
to identify the satellite identification (ID).
This process can be tracked on the display.
After successful identification „LOCKED“ ap-
pears in the display. Should not be identified the satellite of your choice, the antenna
corrected the position. Once the satellite is correct, the display will show it (eg ID:AS1).
After a successful search, the receiver is assured by the antenna.
4. The Seaman 45 and 60 has a tracking function, which allows to receive even while
driving a permanent signal. This is fully automatic and requires no adjustments to the
equipment.
5. The antenna is constantly moving in order to detect any changes in the position. If your
vehicle at a fixed location, the movement of the antenna cause irritating noises. There-
fore press the „SLEEP“ button on the control unit to turn off the tracking function of the
antenna. To activate the automatic positioning again, please restart the control unit.
6. When the tracking function is not disabled and there was no movement on the ve-
hicle at least for 10 min., the function is switched off automatically. If the antenna or
the vehicle moves easily (eg walking in the vehicle), the tracking function is activated
automatically.
Note: Changing the satellite is only possible shortly after switching on the power (as
described in point 3) or after successful satellite search.
Preprogrammed satellites:
ENGLISH ENGLISH
08
09
The following settings are only for the
Seaman 37 (without AutoSkew). An overview
of the skew settings can be found on page 11.
ASTRA 2 Position for Astra 2 to 28,2° East
ASTRA 3 Position for Astra 3 to 23,5° East
ASTRA 1 Position for Astra 1 to 19,2° East
HOTBIRD Position for Hotbird to 13° East
ASTRA 4 Position for Astra 4 (Sirius) to 4,8° East
THOR Position for Thor to 0,8° West
HISPASAT Position for Hispasat to 30° West
TURKSAT Position for Turksat to 42° East
0°
+90°
-90°
… 13 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Megasat Seaman 45 GPS-Auto Skew at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Megasat Seaman 45 GPS-Auto Skew in the language / languages: English, German as an attachment in your email.

The manual is 1,47 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info