15
GB
3 Operating
Buttons on the control unit
Use the buttons on control pad
to operate the massage seat cover:
•
Switch on the device by pressing On/Off button
. The LED illuminates. The
device starts automatically with the 3D massage on the full back setting. The
LED shows the current massage region.
•
Select the region you wish to massage with the Shiatsu massage button
.
1. Entire back
The Shiatsu massage heads
move from the “Park” position at the base
of the backrest, up to the shoulder area, massaging the back in a circular
motion whilst doing so. Once the uppermost position has been reached, the
direction of rotation of the massaging heads is reversed. The heads then
travel down to the base of the backrest. Once the heads reach this point, the
direction of rotation is reversed again and then travel up the back again.
2. Lower back
The Shiatsu massage heads
travel up and down the lower half of the
back in a circular motion. The reversal of the direction of rotation takes place
when the respective end positions are reached.
3. Upper back
The Shiatsu massage heads
travel up and down the upper half of the
back in a circular motion. The reversal of the direction of rotation takes place
when the respective end positions are reached.
4. Stop
•
You can enhance the shiatsu massage at any time with a vibration massage
for your thighs by pressing the vibration massage button
.
• The
vibration massage in the upper thigh area can be operated separately by
pressing vibration massage button
. The LED next to “L” illuminates and
both vibration massage motors
are switched on. They begin with a gentle
massage. Press button
again and the vibration level increases (medium
intensity massage). The LED next to “M” illuminates. Press button
a third
time and the vibration level increases (highest intensity massage). The LED
next to “H” illuminates. After button
is pressed a fourth time, the vibration
massage is switched off and the LED extinguishes.
•
The heat function can be activated at any time with the shiatsu massage,
during which the vibration massage can also be activated. Press the heat
button
to activate the function; the LED on the control unit and the mas-
sage heads light up red. The heat is radiated through the massage heads
.
Press the button
again to de-activate the heat function; the LED and the
red light of the massage heads go out.
•
Timer function:
The automatic switch-off function is activated with selection of the massage
region and is preset to 15 minutes. You can set the automatic switch-off
function to 5, 10 or 15 minutes by pressing the TIMER button
.
