477245

Medisana HKC 60114 Manual

16
Zoom out
Zoom in
Previous page
1/76
Next page
Additional information for the heat pad for neck and back (Art. 60124 HKN)
This specially-shaped back and neck pad is especially designed for use on these
areas of the body. It is individually adjustable to your body thanks to hook and loop
fasteners in the neck and hip areas. G
3 Miscellaneous
3.1 Troubleshooting
This unit is equipped with the active protection system APS TECH. The unit detec-
ts different causes of errors and emits corresponding alarm sounds if necessary. In
the case of an error, the power LED will light up in red.
G
3 beeps in 1-second interval and power LED lights up in red:
The connection cable of the control unit is not properly connected to the heat pad or
another electrical defect is present. Please check the cable connection. Is the cable
connected properly, please do not use the heat pad and contact the service center.
3 beeps in 2-second interval for one minute and power LED lights up in red:
The heat pad is broken, folded or fully covered. Please use the heat pad only
according to this instruction manual and pay attention to all points in the safety
information chapter.
G
Constant beeping and power LED lights up in red:
Important components are damaged or there is a short circuit. Please do not use
the heat pad and contact the service center. G
If there is no function at all after switching on the heat pad (power LED shows
no light and no beeps can be heard), please check if the mains plug is correctly
plugged in the mains outlet. If this is the case, the heat pad is defect. Please do
not use the heat pad and contact the service center. G
Heat pad
3.2 Cleaning and maintenance
•
Before cleaning the pad, unplug it from the mains outlet and let it cool down for
at least ten minutes.
The heat pad can be cleaned with a soft brush when dry.
The heat pad may be carefully washed by hand. Ideally you should place the
heat pad in a bathtub with warm water and a little mild detergent and squeeze
it gently.
Rinse the pad several times to get rid of any remaining detergent.
Never use strong detergents or hard brushes.
To dry, lay the pad flat on a moisture-absorbent towel or mat.
Only use the blanket again once it is completely dry.
E
E
E
E
E
E
E
E
The heat pad is equipped with a removable control unit
60114 / 60124 / 60144: “HKC, -M, -N”). Unplug the control unit from the heat
pad by pulling out the connection cable from the plug on the heat pad.
(Art. 60104: “HKS”; Art.
•
•
•
•
Reconnect the control unit to the heat pad in the
correct manner (please see the sketch, the arrow
markings are showing towards each other).
You should untangle the cable from time to time.
Store the unit in a clean and dry place, laid out flat
with nothing covering or resting on top of it.
•
•
•
•
•
•
12
GB
2 Operating / 3 Miscellaneous
… 16 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Medisana HKC 60114 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Medisana HKC 60114 in the language / languages: English, German, Dutch, French, Italian, Portuguese, Swedish, Spanish, Finnish as an attachment in your email.

The manual is 1,39 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info