10
2
Operating /
3 Miscellaneous
GB
2.4
HDC heated
underblanket
To switch off the blanket, return the switch to position 0. The red power LED
will go out, indicating that the unit is switched off. Now unplug the blanket
from the mains outlet.
Level 3 of the device is intended for heating up, levels 1 and 2 are for con-
tinuous operation. The blanket will switch off automatically after approx. 9
hours of continuous use. To switch it back on, first move the switch back to
position 0 then back to the desired heat setting.
Unplug the blanket from the mains outlet when it is no longer in use.
MEDISANA HDC
Plug the blanket into the mains outlet and move the selector switch from
position 0 to position 1. The orange power LED will light up. You will feel the
blanket gradually warming up. This will be even more noticeable if it is covered
with a quilt. If you require a higher temperature setting, move the switch to
one of the higher settings, position 2, 3 or up to the maximum heat setting,
position 6. Should the blanket get too warm for you, slide the switch back to
a lower setting.
To switch off the blanket, return the switch to position 0. The orange power
LED will go out, indicating that the unit is switched off.
The heated underblanket is designed in such a way that settings 1, 2 and 3 are
suitable for continuous use while you sleep. Settings 4, 5 and 6 are best suited
to pre-warming the bed. The blanket will switch off automatically after approx.
9 hours of continuous use. To switch it back on, first move the switch back to
position 0, then back to the desired heat setting.
Unplug the blanket from the mains outlet when it is no longer in use.
• Before washing the blanket, unplug it from the mains outlet and let it cool
down.
• Unravel the cable if it is tangled.
• Ideally, you should store the underblanket folded in its original carton in a
clean and dry place.
MEDISANA HDS
The HDS underblanket may be carefully washed by hand. Never immerse the
control switch in water as moisture must not be allowed to get into the unit.
Ideally you should place the blanket in a bathtub with warm water and a little
mild detergent and squeeze it gently. Make sure that the control switch and
mains lead remain outside the bathtub at all times. Rinse the blanket several
times to get rid of any remaining detergent.
To dry, lay the blanket flat on a moisture-absorbent towel or mat. Only use the
blanket again once it is completely dry.
3.1
Cleaning and
maintenance
